User manual PANASONIC WJ-MX10

[. . . ] The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] Select either MULTI SEQ SETUP or SPOT SEQ SETUP with the [D] or [C] button, and press the JogDial. G Multiscreen Sequence Setup (MULTI SEQ SETUP) Open the QUAD SEQ SETUP menu to program the sequence steps for displaying quad-split and single input images. MULTI SEQ SETUP Video switcher functions are programmed in this menu setup. G Start Display (START DISPLAY) The image in the selected form will be displayed on the monitor when the recorder is turned on. single image: CH 1 to CH 8 Quad image: QUAD-4A (including 1-4) , QUAD-4B (including 5-8) Multi image: 9SCREEN (including 1-8) Sequence: SPOT SEQ , MULTI SEQ STEP 1 2 3 4 5 6 7 8 CAM ?Move the cursor to the desired step using the [D] or [C] button. Select a camera number with the JogDial, and press the JogDial. The default camera number is identical to the step number. Select the duration for the step with the JogDial, and press the JogDial. Available durations: 2-30S G Multiscreen Selection (MULTI SEL MODE) When pressing the [MULTI SCREEN SEL] button on the front panel, the monitor display will change as follows depending on the setup. Repeat steps 1, 2, and 3 until all steps are programmed, or press the [SETUP/ESC] button to return to the SEQUENCE SETUP menu. Select the duration for the step with the JogDial, and press the JogDial. XX G System Log (SYSTEM LOG) The system log is displayed on the monitor with event numbers, dates, times, and causes. 03 10:50:20 LS1 G HDD Hour Meter (HDD HOUR METER) The meter shows how many hours each hard disk has been operated in playback, recording and idle. The built-in HDD needs replacement when the hour meter reads around 30 000 H. abbreviation TML WR1 Cause Thermal error Description Temperature exceeds the operating range. Writing error on HDD Master HDD Slave HDD Master HDD Slave HDD Warning, HDD is nearing to the end. RV2 HD1 HD2 FL% G Default (DEFAULT) This enables the recorder to restore all setup data to the default values. Press the JogDial to move the cursor to DEFAULT. When the cursor is on SET?, press the JogDial again. Select YES or NO with the JogDial, and press the JogDial. When all setup data are reset to the defaults, "SET DONE" is displayed for a few seconds and then changes to SET?. [. . . ] RESTART ? SET DONE 8 Restarting (RESTART) This command closes the DISK MENU, and returns to normal operation. Follow the procedures described above when the DISK MENU appears again after restarting. This happens when the settings have been changed. To cancel the PLAY ONLY mode, follow these procedures described above and select YES for RESTART. [. . . ]