User manual PANASONIC WV-CP650

[. . . ] Colour CCTV Cameras WV-CPR650/WV-CPR654 ENGLISH (Lens : option) Before attempting to connect or operate this product, please read these instructions completely. FRANÇAIS ENGLISH VERSION CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN For U. K. FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY. WARNING THIS APPARATUS MUST BE EARTHED IMPORTANT The wires in this mains lead are coloured in accordance with the following code. Green-and-yellow: Earth Blue: Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol I or coloured green or green-and-yellow. The wire which is coloured blue must be connected to the terminal in the plug which is marked with the letter N or coloured black. [. . . ] -22- DELAY TIME This item is used to select the time to transmit the acknowledge request when communicating on a twoline connection. Move the cursor to the DELAY TIME parameter. Note: This item appears only when a two-line connection is used. · Installation of Software for RS485 Communication 1. Insert the Install Disk 1 to the C drive. When the window that says "Please insert the disk labeled: "Disk 2" into drive C:" appears on the monitor screen, insert the Install Disk 2 and press . When the installation is completed, the window that says "485_GUI Setup was completed successfully. " appears on the monitor screen. After installation of 485_GUI Setup is completed, open 485_GUI Setup, and set the RS485 communication parameters. · CAMERA Set Up Move the cursor to CAMERA of the SET UP menu and press . The CAM SET UP menu appears on the monitor screen. Character Cursor 0123456789 ABCDEFGHIJKLM NOPQRSTUVWXYZ (). , '":;&#!?= +-*/%$ÄÜÖÆÑÅ SPACE POSI RET END RESET . . . . . . . . . . . . . . . . Pointer Character Area Command Editing Area 1. Camera Identification (CAMERA ID) Setting You can use the camera identification (CAMERA ID) to assign a name to the camera. The camera ID consists of up to 16 alphanumeric characters. You can select whether to have the camera ID displayed on the monitor screen or not. ** CAM SET UP ** CAMERA ID OFF ALC/ELC ALC SHUTTER --AGC ON SENS UP OFF SYNC INT WHITE BAL ATW MOTION DET OFF LENS DRIVE DC RET CAMERA ID menu 3. Move the cursor to the character you want to change by pressing / / / . The selected character appears in the editing area. (The pointer in the editing area moves to the right automatically at this moment. ) 5. Repeat the steps above until all characters are edited. To enter a blank space in the CAMERA ID Move the cursor to SPACE and press . To edit a specific character in the CAMERA ID 1. Move the cursor to the editing area by pressing . To edit the CAMERA ID 1. Move the cursor to the CAMERA ID parameter. The cursor on the letter "0" starts blinking. Move the pointer to the character to be edited by pressing or . [. . . ] Select VIDEO if you are using the auto iris lens that requires a video drive signal. -37- 10. Special Menu (SPECIAL) This menu lets you adjust and set up the video signal of the camera to meet your requirements. Move the cursor to RET on the bottom line of the CAM SET UP menu and press or simultaneously for 2 seconds or longer. The SPECIAL menu appears on the monitor as shown below. 10-2. [. . . ]