User manual PARASOUND CDP2000

[. . . ] Accessories -- Do not place this product on an unstable cart or stand. The product may fall causing bodily injury and damage to the product. A product and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the product and cart to overturn. [. . . ] yeilding higher resolution than some "24/96" players. The C/DP-2000 Ultra also incorporates the PMD-100 High Definition Compatible Digital process decoder developed by Pacific Microsonics. This decoder performs precise decoding of HDCD encoded recordings and is also a superior digital filter that enhances the sonic quality of non-HDCD encoded recordings. Please take a few moments to read these instructions so you may fully understand how to maximize the performance capabilities of your belt drive CD player. Unpacking Carefully unpack your CD player and remove all the enclosed accessories: CD clamper, remote control, AC cord. Be sure to inspect the unit for any possible shipping damage. If you see any, contact your Parasound Dealer immediately. Save all the packing material in case you need to ship the unit for repair. Before you proceed, find the serial number located on the rear panel of your amplifier and record it here for reference: Serial #____________________ Date of Purchase____________________ Installation Your C/DP-2000 Ultra should be placed on a level and sturdy surface, out of direct sunlight. It should be in a well-ventilated area, away from heating ducts or radiators. The area must be free of dust or excessive humidity. Located your CD player away from your speakers to minimize vibrations that could interfere with the optical laser. This could cause the error correction circuits to operate excessively for other than defects in the CDs themselves. The unit should not be placed near any component that generates heat or a strong magnetic field, such as a power amplifier. Do not place your C/DP-2000 Ultra near your radio or TV tuner since digital circuitry uses very high frequency signals that could cause interference with clear broadcast reception. Additionally, RF radiation from radio or TV tuners could interfere with the clarity of CD reproduction. A Note on Condensation and Dew If your C/DP-2000 Ultra is brought directly from a cold location to a warm room or if it is placed in a very damp room, moisture may condense on the laser lens within the unit and the player may not operate. If this occurs, remove the disc and leave the player in a warm, dry place for about an hour so the moisture can evaporate. -5- Making Connections to your C/DP-2000 Ultra Before making any connections, turn off the power to your preamplifier and power amplifier. Once the inputs have been connected, plug the AC cord into any convenient outlet. Analog Output Connections There are two analog output connections on the rear panel of your C/DP-2000 Ultra: RCA connectors for unbalanced line outputs and XLR connectors for balanced line outputs. You may use the RCA and XLR connectors simultaneously if you wish. RCA Jacks Connect the left and right RCA output jacks to any line level RCA input on your preamplifier with a pair of high-quality audio interconnect cables. [. . . ] To avoid risk of electric shock, do not remove the top cover. To keep it clean use only a soft cloth and never use any solvents or abrasives. Since dust and dirt can cause problems, keep the plexiglas door closed when you are not using the C/DP-2000 Ultra. Fingerprints may be removed with a soft cloth moistened only with a few drops of clear water. [. . . ]