User manual PARKINSON COWAN SN55GLMWN

[. . . ] Read the booklet thoroughly before you use the cooker. Keep the booklet in a safe place so that anyone who uses the cooker can read it. Pass the booklet on with the cooker if you give or sell it to someone else. For your safety The cooker is designed for domestic use to cook food. You must not use it for any other purpose. [. . . ] For more stubborn marks you can use a soap-filled pad such as 'Brillo'. After cleaning the cooker parts, dry them thoroughly before you put them back. When replacing hotplate burner parts 1. Crown to body (Do not try to force the crown on to the body). Make sure that the hole in the crown is over the electrode. Check that the two longer location pegs sit in the slots in the body. When the crown is in this position let it fall freely on to the body. Check that the crown can be moved slightly from side to side. Cap to crown Place cap centrally on the top of crown (enamel side up). Move sideways and front to back to check the cap is properly fitted. Check for ignition If a burner will not light then you need to check the crown and cap positions. The grill Clean the grill frequently using hot soapy water. After use you can soak the grill pan for a few minutes and then clean it using mild abrasives or a soap filled pad such as 'Brillo'. If you do not do this, the door glass could fall forward. 4 Using both hands, gently tilt the top of the door glass towards you. Lift it slightly to disengage the locators at the bottom of the door. 5 Clean the outer and inner glass using hot soapy water and mild abrasives such as 'Jif'. DO NOT try to clean the aluminium foil which is inside the door. The foil is there to keep the door cool, if it is damaged it will not work. 6 Replace the glass by holding it in both hands and gently placing the locators into the holes of the brackets at the bottom of the door, and make sure the screw location holes line up. 7 Hold the glass in place with one hand and replace the cross head screws into the location holes, with the other hand. 8 Tighten the screws using a pozidrive screwdriver. Close the door. 24 Installing the cooker For your safety This cooker must be installed and serviced by a competent person as stated in the Gas Safety (Installation & Use) regulations current editions and the IEE Wiring Regulations. It is important that the cooker is suitable for your gas supply. Your installer should check the data badge. [. . . ] Remove oven burner by removing the spring clip from the right hand side of the oven burner and slide burner off injector whilst easing it forward and taking care not to strain the F. S. D. Connect the pressure gauge to the oven injector. Check the supply pressure by turning the thermostat on and one hotplate tap full on and light the appropriate burner. The pressure should be either:(i) For Natural Gas 20mbar (ii) For LP. GasThe pressure must be set to 28 mbar for use on butane or 37 mbar for use on propane. [. . . ]