User manual PARKSIDE KH 3038 SCROLL SAW

[. . . ] Before reading, unfold both pages containing illustrations and familiarise yourself with all functions of the device. The following pictograms are used in these operating instructions / on the device: Read instruction manual!Keep children away from electrical power tools!Risk of loss of life by electric shock from damaged mains lead or mains plug! [. . . ] All parts must be correctly attached and fulfil all the requirements necessary to allow the electrical power tool to operate properly. Damaged safety equipment and components must be properly repaired or replaced at a competent electrical equipment repair centre unless otherwise indicated in the operating instructions. damaged switches must be replaced at a Customer Service Centre. Never use an electrical power tool that cannot be switched on and off properly. The use of inserted tools and accessories other than those recommended by the manufacturer could lead to you being injured. Have your electrical power tool repaired at an electrical equipment repair specialist. This electrical power tool complies with the relevant safety regulations. Repairs may only be carried out by a specialist electrical repair centre using original spare parts, otherwise injury could occur to the user. J Ensure that the scroll saw stands on a level, J Do not touch the mains lead if it becomes damaged or cut through while you are using the device. Pull the plug out of the mains socket immediately and have the device repaired by a horizontal surface. Always work with the mains lead leading away from the rear of the device. If a dangerous situation arises, pull the mains plug immediately out of the mains socket. Always switch on the electrical power tool before moving the workpiece against it. Otherwise there is the risk of kickback. Do not cut moist materials or damp surfaces, Use only undamaged, defect-free saw blades 7 . Distorted or blunt saw blades 7 can break or cause a kickback. Ensure that the teeth on the saw blade 7 point downwards before you mount it in the device. Keep your hands away from the area of the saw blade. Before sawing, check the workpiece for foreign bodies such as nails etc. Injury and / or damage to property may result from the saw blade striking nails etc. Always keep the device clean, dry and free from oil or grease. Switch off the device before you remove any wood residue from around the saw blade. [. . . ] Pull the mains plug out of the socket before you carry out any task on the device, J Insert the saw blade 7 through the opening in the saw table 6 . Ensure that the teeth of the saw blade 7 point forwards and downwards. J Suspend the saw blade 7 in the bottom blade mount 14 . J Then hook the top pin of the saw blade 7 in the recess provided for this purpose in the top saw blade mount 8 . [. . . ]