User manual PARKSIDE KH 3115 BELT SANDER

[. . . ] Protective cover Dust extraction spout Belt adjuster screw Tensioning lever Dust collection bag Rated consumption: Nominal voltage: Belt no load speed: Belt /sanding speed at maximum speed: Abrasive surface: Belt: 900 W 230 V ~ 50 Hz n0 650 rpm 350 m/min 75 x 150 mm 75 x 533 mm Protection class: Weight: Sound pressure level: Sound output level: Vibration: II/ 3. The PEBS 900 belt sander has full-wave electronics with additional control electronics, overload control, soft start and power control. Soft start with inrush current limiting. In addition, please read the advice in the accompanying booklet called "Safety advice" before using the equipment for the first time. [. . . ] Press the ON/OFF switch ´ and secure it in the pressed position with the locking knob ¿ Press the ON/OFF switch ´ and then release it ATTENTION: Before you carry out any work on the belt sander always pull the plug out of the mains socket. 1) Release the tensioner for the sanding belt by turning the tensioning lever ¾ fully outwards (see figure ). The belt holder is now open and sanding belt can be removed. 2) Next insert a new sanding belt or change the belt for one suitable for a different material or one with a different grit. IMPORTANT: The direction of the arrow on the inside of the sanding belt must agree with that on sander housing (see Fig. 3) Fully tension the sanding belt ­ turn the tensioning lever I back into its initial position. 4) Lift up the sander and switch it on. Adjust the belt tracking by turning the adjuster screw º until the edge of the sanding belt is flush with and runs parallel to the slider plate. Always make sure that the sanding belt does not cut into the housing. Check the sanding belt regularly and re-adjust if necessary using the adjuster screw º. Always switch on the belt sander before making contact with the material and only then guide the sander on to the workpiece. uSE LIGHT SANDING PRESSURE ONLY Use the lightest possible pressure when sanding. The self-weight of the belt sander alone is quite sufficient for good sanding performance. In addition, by working this way you will achieve a smoother surface and use less energy. MATERIAL REMOVED AND SURFACE FINISH The amount of material removed by sanding and the quality of the surface finish achieved depend on the belt speed and the grit size of the sanding belt (see section on "Belt speed and sanding sheet"). The following basic rules apply: the higher the rpm/belt speed you use, the more material is removed and the finer is the sanded surface. SANDING PROCEDURE With the sander switched on, bring it into contact with the workpiece and move it forward carefully. Vacuum extraction of dust makes disposal easier, prevents the build up of stubborn dust deposits and keeps dust out of the air you are breathing. It will also prevent sanding debris from getting on to the workpiece surface and leaving grease or burn marks. pull the dust collection bag µ over the supplied adapter and attach it to the dust extraction spout ¶. The stirrup-shaped adapter ensures that the dust collection bag is fully opened out to accept the sanding dust (see Fig. If there is an explosive mixture of dust and air you must use a vacuum device especially intended for that purpose. [. . . ] 21, D-44867 Bochum, hereby declare that this product complies with the following EU directives: Machinery directive: Low voltage directive: Electromagnetic compatibility: Applicable harmonised standards: Brand, description of the machine: Bochum, 31. This piece of equipment is covered by a 3-year warranty as of the date of purchase. The equipment was produced with the greatest of care and underwent thorough testing before delivery. In the unlikely event of detecting a functional defect, please return the equipment in its original packaging with the proof of purchase to the closest service address. [. . . ]