User manual PARKSIDE KH 3145 ELECTRIC TACKER

[. . . ] Page Page Page Page Page Page 6 6 6 6 6 6 Safety Specific safety advice for this tool . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 7 Operation Loading the magazine . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Setting the impact force. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Switching on and off . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] O nly use the tool if the mains lead O is undamaged. A damaged mains lead presents a danger to life from electric shock. Have repairs to the mains lead carried out only by an electrician or at the relevant service centre. A lways guide the mains lead O away from behind the hand grip Q to the rear of the tool. D o not use the tool to fix electrical cabling in place. To avoid the risk of injury! J nsure that staples and nails cannot strike E people or animals. GB / IE 7 Safety / Operation rotect your eyes. This also applies to people who may be helping with the work by supporting or holding the workpiece. J efore you start to use the tool, check that it is B in perfect condition. J ake sure the tool is switched off before you M load the magazine T. To do this set the On / off switch I to position "O". J L Setting the impact force A tip!j elect the lowest impact force required for stapling. S j ou can set the impact force at any value beY tween "1" (lowest impact force) and "7" (highest impact force) using the impact force controller Y. L To work safely! Switching on and off J efore undertaking any type of work with the tacker B make sure that materials and workpieces are safely held in position. If necessary have a second person on hand to support or hold the items steady. J Do not use the tool on moist or wet materials. J f you have finished using the tool or are taking I a prolonged break from your work disconnect the mains lead O from the mains. m Attention!J onnect the tool to the mains only when it is C switched off. To do this set the On / off switch O to position "O". To switch on j et the On / off switch I to position "1" (see Fig. S To switch off j et the On / off switch I to position "O". S m Blow count: The Electric Tacker PET 23 VARIO is designed for 30 blows per minute. [. . . ] j eep the tool safe from unauthorised use. K j Keep staples and nails in secure containers. L Disposal The packaging is wholly composed of environmentally-friendly materials that can be disposed of at a local recycling centre. Do not dispose of electrical tools with the household rubbish !In accordance with European Directive 2002 / 96 / EC about waste electrical and electronic equipment and its transposition into national legislation, worn out electric tools must be collected separately and taken for environmentally compatible recycling. [. . . ]