User manual PARKSIDE KH 3169 ROUTER

[. . . ] Before reading, unfold the page containing the illustrations and familiarise yourself with all functions of the device. Page Careful handling and use of electrical power tools . Page Safety advice relating specifically to this device . The following icons / symbols are used in this instruction manual: Wear hearing protection, dust protection mask, protective glasses and protective gloves. [. . . ] Check before use that the router is firmly seated in position, otherwise there may be a risk of injury or accident. If a dangerous situation arises, pull the mains plug immediately out of the mains socket. Before you insert the mains plug into the socket, always check that the device is switched off. Accidents can happen if you carry the device with your finger on the ON / OFF switch or you have already switched the device on before you connect it to the mains. Always switch on the device before guiding it against the workpiece, otherwise there may be a risk of injury from kick-back. After a routing task has been completed, lift the device off the workpiece and turn the clamping lever to bring the device into its top position and then switch it off. Switch the device off and allow it to come to a complete standstill before you put it down, otherwise there may be a risk of injury from rotating parts. Never machine over metal objects, nails or screws, otherwise there may be a risk of injury or damage to the device. Hold the device only by the insulated handle if there is the risk that you might cut through a Safety advice relating specifically to this device This is much safer than holding it in your hand. For this reason, always make sure that nobody is placed in any danger and that there are no inflammable materials near the working area. Be aware that persons operating the tool or in its vicinity may be at risk of being in contact with or inhaling dusts. The most common applications of this bit include rounding the edges of window frames, cupboards, tabletops, shelves and mantelpieces. Once you have made yourself familiar with this general safety advice for electrical power tools, and with the help of the device's operating instructions you now know about all the functions of and how to handle your electrical power tool, you are finally in a position to start work. Observing the instructions and advice will maximise your safety while working with the device. Corner rounding bit with bearing: Corner rounding bits are suitable for profiling edges in frames and framework, especially working with solid woods, such as spruce, beech, oak and alder. Slot cutter, with two cutting edges: Particularly suitable for solid wood, boards, e. Surfaces, slots for letters or butt jointed connections, notches, tongue and groove joints etc. Router bits made from high speed steel (HSS) are suitable for machining soft materials, such as plastic or softwood. Use only routing tools with an allowable speed at least as high as the highest no-load speed of the device!The shank diameter of the router bit must correspond with that of the collet!Inserting the router bit Before carry out any work on the device, first pull the plug out of the mains socket. Wear protective gloves when inserting or replacing a router bit. [. . . ] Dirty devices increase the risk of injury (e. You will work better and more safely with clean cutting tools. Do not allow any liquids to enter the inside of the device, otherwise there may be a risk of electric shock. Never use petrol, solvents or cleaning agents that might attack plastic. [. . . ]