User manual PARKSIDE KH3014 SOLDERING GUN WITH HOLDER

[. . . ] the device is not intended for commercial use. Any other use or modification to the device shall be considered as improper use and could give rise to considerable dangers. The manufacturer will not accept liability for loss or damage arising from improper use. Safety advice Safety advice Below may result in electric shock, fire and/or serious injury. [. . . ] J If a dangerous situation arises, pull the mains plug immediately out of the mains socket. Do not breathe air contaminated with soldering fumes. J When working with the device for long periods do not allow the fumes from soldering to build up. Do not eat, drink or smoke in rooms where soldering is carried out. Otherwise your hands may transfer any adhering traces of lead via food or cigarettes into your body. J Always wash your hands immediately after soldering . J Do not dispose of soldering waste with the household rubbish. Soldering waste must disposed of as special waste. Careful handling and use of electrical power tools A) When not in use always ensure that electrical power tools are kept out of reach of children. Do not let any one use the device if he or she is not familiar with it or has not read the instructions and advice. Electrical power tools are dangerous when they are used by inexperienced people. Check for broken parts or parts that are damaged to the extent they detrimentally affect the functioning of the device. Have any damaged parts repaired before you use the device. Many accidents have their origins in poorly maintained electrical tools. Safety advice / Before first use Use of attachments or accessories other than those recommended here could lead to you suffering an injury. 4 into the opening of the multifunctional holder 7 . J Push the helical spring 4 into the opening as far as it will go. Allow the soldering pencil to heat up without a soldering tip. Insert a soldering tip 2 into the soldering pencil 1 to a depth of half of its shaft length. Tighten the clamp screw 3 using a Phillips screwdriver. The mains voltage must correspond with that shown on the sander rating plate. Equipment labelled as 230 V may also be used with 220 V. [. . . ] This warranty does not affect your statutory rights. They can be disposed of at your local recycling facility. Do not dispose of electrical devices with the household rubbish! In accordance with European Directive 2002 / 96 / EC (covering waste electrical and electronic equipment) and its transposition into national legislation, worn out electrical devices must be collected separately and taken for environmentally compatible recycling. [. . . ]