User manual PARKSIDE PBS 600 A1

[. . . ] Safety class II Wear hearing protection, dust protection mask, protective glasses and protective gloves. Keep children away from electrical power tools!Risk of loss of life by electric shock from damaged mains lead or mains plug!Could give rise to considerable dangers. [. . . ] Loose clothing, jewellery or long hair can become trapped in moving parts. G) If vacuum dust extraction and collection devices are fitted do not forget to check that they are properly connected and correctly used. The use of these devices reduces the hazard presented by dust. Careful handling and use of electrical power tools 3. personal safety A) Remain alert at all times, watch what you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the device can lead to serious injury. B) Wear personal protective equipment and always wear safety glasses. The wearing of personal protective equipment such as dust masks, non-slip safety shoes, safety helmets or ear protectors, appropriate to the type of electrical power tool used and work undertaken, reduces the risk of injury. Always use an electrical power tool that is intended for the task you are undertaking. By using the right electrical power tool for the job you will work more safely and achieve a better result. This is much safer than holding it with your hand. Never support yourself by placing your hands near or in front of the device or the workpiece surface. If a dangerous situation arises, pull the mains plug immediately out of the mains socket. Always work with the mains lead leading away from the rear of the device. Avoid contact with the moving sanding belt. do not work on moistened materials or damp surfaces. Always switch on the device before placing it against the workpiece. After sanding, lift the device from the workpiece before switching it off. When working always hold the device securely with both hands (see Fig. Switch the device off and allow it to come to a complete standstill before you put it down. When taking a break from your work, before carrying out any tasks on the device itself (e. [. . . ] The weight of the belt sander alone is adequate to produce good sanding results. By adopting this approach you will also prolong the life of your sanding belts and obtain a smoother workpiece surface. Sanding and surfaces: The sanding output and the quality of the surface finish obtained are determined by the belt speed and the grade of grit on the sanding belt (see the section on "Selecting the correct rotational speed and sanding belt"). If it is necessary to use the reducer piece 13 , push the reducer piece into the adapter for external vacuum extraction 12 . [. . . ]