User manual PARKSIDE PDEXS 150 A1

[. . . ] Speed: Sanding stroke: Sound pressure level: Sound power level: Uncertainty K: 10500 min-1 5 mm 89 dB(A) 100 dB(A) 2. 5 dB For your own safety, wear suitable personal protective equipment. Never use oxygen or other combustible gas as the energy source. Never exceed the maximum working air pressure of 6. [. . . ] Use the appliance only with a sanding sheet in place. The appliance must always be kept clean, dry and free of oil or grease. A workpiece held in a clamp or vice is kept more securely in place than one held by your hand. Never support yourself by placing your hands near or in front of the device or the workpiece surface. Ensure that flying sparks do not endanger the safety of other people. remove combustible materials from your working area. Flying sparks are often created while you are abrading metals. Introduce the appliance to the work piece with it switched on. On task completion, lift the appliance from the work piece and then switch it off. Permit the switched off appliance to come to a complete standstill before putting it down. The use of inserted tools or accessories other than those recommended in the operating instructions could lead to you suffering an injury. Before use / Preparing for use before use Selecting the grinding Disc Metal Removal and Surface: The rate of metal removal and the surface quality are determined by the grain size of the grinding disc. Lease note that corresponding grinding discs with different grain sizes should be used for processing different materials. You may ensure this in any of the following ways: Connect a service unit with an oiler to the compressor. Install a line oiler in the compressed air line or at the compressed air device. 3­5 drops of pneumatic oil by hand into the plug nipple 3 every 15 minutes of operation. The air sander is fitted with a hook and loop fastening, which allows for quick and easy replacement of sanding discs. Lift the grinding disc at the side and pull it off from the backing pad 6 in order to remove it. Note: Before securing a new sanding sheet, remove all dust and dirt from the sander plate 6 . Note: The air sander must be operated using cleaned and condensate-free compressed air only and its maximum allowable working pressure of 6. 3 bar at the device must not be exceeded. Note: The compressed air source must be fitted with a (filter) pressure reducer so that the air pressure can be regulated. [. . . ] The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. Your statutory rights are not restricted in any way by this warranty. The warranty period will not be extended by repairs made unter warranty. this applies also to replaced and repaired parts. [. . . ]