User manual PARKSIDE PDFP 500 A1 AIR PAINT SPRAY GUN

[. . . ] Before reading, unfold the page containing the illustrations and familiarise yourself with all functions of the device. The following pictograms are used in these operating instructions / on the device: Read instruction manual!Never point the device at people or animals. Wear respiratory protection with active charcoal filters and goggles. [. . . ] do not treat an injection as a simple cut. A high pressure jet may inject toxins into the body and cause serious injuries. If the spray is injected into the skin, seek medical help immediately. Pay attention to any possible dangers of the material being sprayed. Note the markings on the container or the manufacturer's information relating to the material being sprayed, including the instruction to use personal protective equipment. The manufacturer's in-structions must be followed to reduce the risk of fire, as well as injuries caused by toxins, carcinogens, etc. Never spray without the nozzle head in place. The use of a special nozzle insert with the appropriate nozzle head reduces the probability of a high-pressure jet penetrating the skin and injecting toxins into the body. Important: Do not exceed the maximum working pressure of 3 bar. Operate the product only with cleaned, condensate- and oil-free compressed air and never exceed the maximum working air pressure at the device of 3 bar. The compressed air source must be fitted with a (filter) / pressure reducer so that the air pressure can be regulated. In order to operate this device you require a flexible compressed air hose with quick-release coupling and an appropriate source of compressed air. Observe the operating and safety instructions of the compressed air source and any special instructions concerning paint preparation. The surfaces become rough and develop poor adhesion properties. If the working pressure is too low on the other hand, the paint material is not sufficiently atomised. Use the filter pressure reducer of the compressed air source to set the working pressure to 3 bar. In order to stop spraying, release the trigger 8 again. Otherwise all non-covered areas or surfaces may become soiled. Make sure that the spraying surface is clean, dry and free of grease. roughen smooth surfaces and then remove the sanding dust. Adjusting the round jet: Use the round jet, for example, for small surfaces, corners and edges. The nozzle head 9 can be continuously adjusted vertically and horizontally by turning to the desired position. [. . . ] Use the cleaning brush supplied or a cloth to clean the housing. Never use petrol, solvents or cleaning agents which attack plastic. First unscrew the nozzle head 9 by turning in an anticlockwise direction . loosen and remove the nozzle 10 by unscrewing it with the installation spanner 11 in an anticlockwise direction - see also Figure B. [. . . ]