User manual PARKSIDE PDSP 1000 A1 SANDBLASTER GUN

[. . . ] Any other use or modification to the device shall be considered as improper use and could give rise to considerable risk of accident. We will not accept liability for loss or damage arising from improper use. The device is intended for private, domestic use only. Cleaned and oil-free Working air pressure setting at the pressure reducer max. [. . . ] Use only materials for the blast medium that are suitable for the sandblasting gun. Take precautions to ensure that other people are not contaminated (dust generation). Ensure that the spent blast medium is trapped and collected so that it can be disposed of in an environmentally compatible manner. Do not remove rating plates or labels - they are safety-relevant parts of the device. If you are inexperienced in the use of this type of device, you should seek out information or training to learn how to handle it safely. NOTE: Operate the sandblasting gun 1 only with cleaned, condensate- and oil-free compressed air and never exceed the maximum working air pressure at the device of 8 bar. NOTE: The compressed air source must be fitted with a (filter) / pressure reducer so that the air pressure can be regulated. Connect the sandblasting gun to a suitable compressed air source by connecting the quick-release coupling of the air supply hose with the plug-in nipple 3 to the sandblasting gun 1 . Always use a suitable blast medium for your sand blasting work. Ground blast furnace slag) with a grading of 0. Ensure that the blast medium is completely dry and not too coarse. Pull the blast medium container 4 off downwards. Fill the blast medium container 4 with the desired amount of blast medium. ensure that the maximum capacity of the container (1000 ml) is not exceeded. Screw the blast medium container 4 back on and lock it in place by inserting and turning it on to the container lid (see Figs. b , C) Carefully prepare the workpiece before sand blasting it. Carefully mask or tape off everything that is not to be sand blasted. Ensure that there is always a minimum distance of 20 cm between the sandblasting gun 1 and the surface being sand blasted. After you finish work, disconnect the device from the compressed air source. NOTE: First disconnect the hose from the compressed air source and only then disconnect the compressed air supply hose from the device. This will ensure that the compressed air supply hose does not wave around in an uncontrolled manner. Always disconnect the device from the compressed air source before you clean or maintain it. [. . . ] The warranty period will not be extended by repairs made unter warranty. this applies also to replaced and repaired parts. Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. Repairs made after the expiration of the warranty period are subject to payment. [. . . ]