User manual PARKSIDE PDT 40 B2

[. . . ] Before reading, unfold both pages containing illustrations and familiarise yourself with all functions of the device. Page 22 Safety of the fastener driving tool. Page 24 Additional safety information for compressed air tackers. Page 25 Preparing the product for use Operation. [. . . ] One moment of carelessness when using the fastener driving tool may result in serious injuries. By doing this you will be in a better position to control the fastener driving tool in unforeseen circumstances.  Before any repair and maintenance work or transport, remove the device from the compressed air source. Do not use the device on scaffolds or ladders.  Never use hydrogen, oxygen, carbon dioxide or other bottled gasses to power this tool as doing so may result in an explosion and thus may cause severe injuries. Do not use the device if RISK the trigger lock 8 is damaged or has been removed. Safety  ever point a fastener driving tool that N is ready to use directly at yourself, other persons or animals.  uring work, hold the fastener driving D tool so that head and body can not be injured by possible kickback due to a fault in the power supply or from hard places in the workpiece.  Never trigger the fastener driving tool into empty space. Following this instruction will prevent danger due to uncontrolled flying fasteners and overloading the device.  Before transporting, disconnect the fastener driving tool from the compressed air network, particularly when using ladders or are moving with an unaccustomed body posture.  t the workplace, only carry the fasA tener driving tool by its grip and never with the trigger actuated. Pay Fasteners may strike completely through thin workpieces or slide off corners or edges to cause a danger to persons. Wearing personal protective devices such as dust mask, non-slip safety shoes, safety helmet or hearing protectors, depending on the type of fastener driving tool and its application, reduces the risk of injuries. 24 GB Safety of the fastener driving tool / Preparing the product for use / Operation  loosening the hose coupling, hold the When hose firmly in your hand to prevent injuries caused by a rebounding hose.  e absolutely certain to use a ¼‘„ threaded B nipple and a quick-release coupling for the compressed air connection.  place your hands near the mouth when Never the device is ready to operate. Check the dePay vice for damage before bringing it into use. If the device exhibits defects, it must not be operated under any circumstances. Never Do insert pointed and / or metal objects into the inside of the device.  do so, press the compressed air hose quickTo release coupling (not included in the scope of delivery) on the ¼“ threaded nipple 4 of the compressed air tacker.  Connect the other end of the compressed air hose to the (filter) pressure reducer on the compressor. [. . . ]  the knurled screw 7 upwards in order to Turn drive the fastener less deeply into the workpiece.  the exhaust air aperture 1 to guide the Turn exhaust airflow in the desired direction. 26 GB  finishing work, disconnect the device from After the compressor. emoving R jammed fasteners  staple or nail gets jammed in the magazine If a slot, immediately disconnect the compressed air supply. [. . . ]