User manual PARKSIDE PFLK 30

[. . . ] Page 12 Declaration of conformity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 12 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 13 6 GB Introduction Soldering pencil PFLK 30 For soldering electronic components and circuit boards produce better results. Be careful to keep these advice notes and if necessary pass them on to a third party. [. . . ] If using an extension lead, always use one that is approved for outdoor use. Always keep the mains lead out of the operating area and run it away from the rear of the device. · Always wear protective glasses when using the device. In addition, it is recommended that you wear protective gloves, a face mask and a protective apron. Before use, always check the device, mains lead and plug for any damage. If any parts are damaged, have them fixed or replaced at a specialist repair centre only. Ensure that no vapours that may be hazardous to health can accumulate when working with the device for long periods. Always provide adequate ventilation of your working area. Switch on the device each time before you bring it into contact with the materials to be soldered. · · · To avoid the danger of injury: Danger of burns!· Before carrying out any work on the device itself, for example, changing the soldering tip, always pull the plug out of the mains socket and allow the device to cool. · Using the device safely: · Before heating the device, check that the soldering tip is firmly seated - the clamping GB 9 Safety/Operation · screw must be fully tightened. When removing the soldering tip make sure that the soldering pencil is switched off and do not use too much force. Slide a new soldering tip fully in so that it hits the stop. Do not heat up the soldering pencil without a tip in place. After use let the soldering pencil cool down in air only. Under no circumstances quench the tip in water!Place the soldering pencil in the stand during any pauses in your work. Place the soldering pencil down only in the special stand or on a fireresistant support pad. If danger arises, pull the mains plug immediately out of the mains socket. Never use the device for a purpose for which it was not intended. GB · · · · Handle the device carefully and treat it with respect. Always keep the device clean, dry and free of oil or grease. Watch what you are doing and always proceed with caution. Do not use the device if you cannot concentrate or you are feeling unwell. · · Operation Note the mains voltage. [. . . ] It has been carefully produced and meticulously checked before delivery. Please keep your receipt as proof of purchase. Contact your service centre by telephone in case of questions pertaining to the warranty. Your goods can be transmitted free of cost only in this manner. [. . . ]