User manual PARKSIDE PHLG 2000 SE

[. . . ] Page 9 9 Information Servicing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page Manufacturer`s declaration of conformity . . . . . . . . . . . . . . . . . . . . . . . Page 9 9 GB 5 Introduction Hot air gun PHLG 2000 SE SE SE For removing, reshaping, preheating, defrosting etc. í Features and equipment Air inlet ON/OFF switch (ON = setting 1 (375° C) or setting 2 (550° C)) Nozzle Heat shield Reflector nozzle Protector nozzle Flat nozzle Reducer nozzle í í Introduction For your safety Please make sure you familiarise yourself fully with the way the device works before you use it for the first time and that you understand how to handle electrical power tools correctly. [. . . ] Pull the plug out of the mains socket immediately and have the device repaired by a suitably qualified person or at your service centre. Do not operate the device if it is damp and do not use it in a damp environment. If you use the device outdoors, always connect it through a residual current device with a maximum trip current of 30 mA. If using an extension lead always use one that is approved for outdoor use. Do not use the device in rain or in wet conditions. Do not suspend or carry the device by the mains lead. Always work with the mains lead leading away from the rear of the device. · · · · · · · · In addition, you should never leave the device working unattended. Bear in mind the high rate of heat generation. If the device is not used carefully, it can give rise to increased risk of fire or explosion. Do not work in the vicinity of easily ignitable gases or materials. Heating of plastics, paints, varnishes etc. Switching off the device: Press the ON/OFF switch into setting , , 0". Setting the air flow and temperature: The switch has two different air flow settings. You can select the combination of air flow and temperature most suitable for your task. Setting I: 300 l/min, 375° C Setting II: 500 l/min, 550° C í Changing the nozzle Reflector nozzle ­ for shaping plastic pipes or tubes: Use the reflector nozzle for shaping plastic pipes or tubes. Fill the pipe or tube with sand and ensure it is closed at both ends. This will prevent the pipe or tube from kinking. Warm the pipe or tube evenly by moving the hot air gun from side to side and backwards and forwards. Protector nozzle ­ for removing paint and varnish: Use the protector nozzle to warm paint and varnish evenly. The spatula shape of the nozzle ensures the air is properly directed. Use a separate spatula for removing paint or varnish. Flat nozzle ­ for detaching glues, softening paint: Use the flat nozzle to soften paint and varnish. [. . . ] Copper pipes are joined using tin solder and must not be heated above 200° C. Use the reflector to defrost water pipes. Warm the frozen section of pipe from its edge towards its centre. Loosening a threaded connection: Threaded connections (e. g. [. . . ]