User manual PARKSIDE PLS 30

[. . . ] Please read the operating instructions below. Be careful to keep these advice notes and if necessary pass them on to a third party. Q Proper use The device is intended for use in soldering electronics and model-making. Use the device only as described and for the indicated purposes. The device is not intended for commercial use. [. . . ] Always let the device cool before you replace components on the device, clean it or check its condition. J After use let the soldering pencil cool down in air only. Under no circumstances quench the tip in water!Place the soldering pencil down only in the special multifunctional holder or on a fire-resistant pad. J Place the soldering pencil in the multifunctional holder during pauses in your work. J Keep the device away from combustible material. J Never leave the device switched on and unattended. Keep your hands away from the hot workpiece. The heat from soldering can be conducted through the workpiece. For this reason you should use the third hand to hold small workpieces. J Avoid placing the hot soldering tip in contact with the plastic parts of the multifunctional holder. Failure to observe this advice may result in damage to the device. J If a dangerous situation arises, pull the mains plug immediately out of the mains socket. Do not breathe air contaminated with soldering fumes. J When working with the device for long periods do not allow the fumes from soldering to build up. Always provide adequate GB/IE/CY 11 Safety advice ventilation of your working area. In addition, it is recommended that you wear protective gloves, a face mask and a protective apron. J Do not eat, drink or smoke in rooms where soldering is carried out. Otherwise your hands may transfer any adhering traces of lead via food or cigarettes into your body. J Always wash your hands immediately after soldering . J Do not dispose of soldering waste with the household rubbish. Soldering waste must disposed of as special waste. 4. Careful handling and use of electrical power tools a) When not in use always ensure that electrical power tools are kept out of reach of children. [. . . ] Continue to feed further solder until the whole joint has a covering of solder. Then quickly remove the soldering tip in order to avoid overheating the molten solder. Allow the solder to harden while not subjecting it to vibration or movement. Note: The flux is either already contained in the solder or applied separately. [. . . ]