User manual PARKSIDE PLS 48 A1 MANUAL 6

[. . . ] Any other use or modification to the device shall be considered as improper use and could give rise to considerable dangers. The manufacturer will not accept liability for loss or damage arising from improper use. GB/IE/CY 7 Introduction Q Features and equipment Soldering pencil Soldering tip Clamp screw Helical spring Clips Third hand Multifunctional holder Solder sponge 1 2 3 4 5 6 7 8 Q Included items Soldering pencil Multifunctional holder Tin solder, 10 grams Soldering tips (1x installed) Solder sponge Operating instructions 1 1 1 2 1 1 Q Technical information Electricity supply: 230 V ~ Frequency: 50 Hz Power consumption: 30 W 8 GB/IE/CY Safety advice Safety advice J CAUTION!Failure to observe the instructions and advice given below may result in electric shock, fire and/or serious injury. 1. Workplace safety a) Keep your working area clean and well lit. [. . . ] Children must never be allowed to play with the device. 10 GB/IE/CY Safety advice b) Remain alert at all times, watch what you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the device can lead to serious injury. Never touch the hot soldering tip or the molten solder. Always let the device cool before you replace components on the device, clean it or check its condition. J After use let the soldering pencil cool down in air only. Under no circumstances quench the tip in water!Place the soldering pencil down only in the special multifunctional holder or on a fire-resistant pad. J Place the soldering pencil in the multifunctional holder during pauses in your work. J Keep the device away from combustible material. J Never leave the device switched on and unattended. j Push the helical spring 4 into the opening as far as it will go. j Turn the helical spring 4 clockwise to fix the multifunctional holder 7 in place. Q Inserting / replacing soldering tips CAUTION!Allow the soldering pencil to heat up without a soldering tip. 1. Insert a soldering tip 2 into the soldering pencil 1 to a depth of half of its shaft length. Tighten the clamp screw 3 using a Phillips screwdriver. j Remove the soldering tip only when the device has been switched off and the soldering tip 2 has cooled. GB/IE/CY 13 Operation Q Operation The mains voltage must correspond with that shown on the sander rating plate. Equipment labelled as 230 V may also be used with 220 V. Q Switching on and off Switching on: j Insert the mains plug into a suitable mains socket. Switching off: j Pull the plug out of the mains socket to switch off the device. Q Third hand CAUTION!The clips 5 on the third hand 6 can become hot while you are soldering the workpiece. Rotate the clips 5 until they are oriented in the required direction. Clamp the workpiece between the two clips 5 . Q Solder sponge CAUTION!The hot soldering tip 2 must never be placed in contact with a dry solder sponge 8 , otherwise the solder sponge may be damaged. [. . . ] This will ensure that your device remains safe to use. If the plug or mains lead needs to be J replaced, always have the replacement carried out by the manufacturer or his service centre. This will ensure that your device remains safe to use. Q Warranty This appliance is guaranteed for 3 years from the date of purchase. It has been carefully produced and meticulous ly checked before delivery. [. . . ]