User manual PARKSIDE PMGS 12 A1 MODELLING AND ENGRAVING SET

[. . . ] Before reading, unfold the page containing the illustrations and familiarise yourself with all functions of the device. General safety advice for electrical power tools . Careful handling and use of electrical power tools . Page Device-specific safety instructions for small drill KH3037 and mains adapter KH3037-1 . [. . . ] Always keep the device clean, dry and free of oil or grease. Children or persons who lack the knowledge or experience to use the device or whose physical, sensory or intellectual capacities are limited must never be allowed to use the device without supervision or instruction by a person responsible for their safety. Children must never be allowed to play with the device. Using the Insertion tool with mandrel 12 : NOTE: Use the screwdriver end of the combination key 23 to release or tighten the screw of the mandrels 12 . insert the mandrel 12 into the electrical tool as described. With the aid of the combination wrench 23 , unscrew the screw from the mandrel 12 . Place the insertion tool you wish to have onto the screw between the two washers. With the aid of the combination wrench 23 , tighten the screw on the mandrel 12 . Switching on and off / Setting the speed range Never use the device for a purpose for which it was not intended or with non-original parts / accessories. The use of tools or accessories other than those recommended in the operating instructions could lead to you suffering an injury. Switching on / Setting the speed range: Connect the plug 3 to the power supply unit 9 by inserting it into the plug-in device 7 provided for such purposes (see Fig. Connect the device to the power supply by inserting the mains plug into the socket. Advice on working with materials / Tools / Speed ranges Use the highest speed when working on steel or iron with the milling bits 20 . Use a short trial on a test piece to determine the optimum rotational speed range for working on zinc, zinc alloy, aluminium, copper and lead. Use the low speed range for working on plastics and low-melting point materials. Use the medium speed range for cleaning, polishing and buffing. Use only the lightest contact pressure of the tool on the workpiece. The following information shall be considered as recommendatory only. Learn by practical experience which tools and settings are the best for the materials you work with. Setting the appropriate speed: Symbols on ON / OFF switch 1 OFF 5 7 10 17 20 Material to be worked on (Drill / grinder switched off) Plastics and low melting point materials Stone, Ceramics Softwood, metal Hardwood Steel Cleaning complex plastic housings or the area around a door lock E. Cleaning cutlery, jewellery, tools (The metal brush is softer than steel) Grinding work on stone, wood; fine work on hard materials such as ceramic or alloyed steel (see Figs. F, G) Cutting metal, plastic or wood Saw blade, Sawing steel, metal, wood or plastic (see Fig. [. . . ] Off and hold it until the disc comes to a complete stop. Never attempt to pull the still rotating cutting disc out of the cut as this could cause kickback. Allow the cutting disc to reach full speed before carefully continuing with the cut. Otherwise the disc could snag, jump out of the workpiece or cause a kickback. [. . . ]