User manual PARKSIDE PSBM 500 A1 MANUAL 6

[. . . ] If you pass the tool on to anyone else, please ensure that you also pass on all the documentation. Features 1 2 3 4 5 6 Drill / hammer drill action switch Ventilation slots On / Off switch Locking button Speed preselector wheel Rotation direction switch 6 GB/IE Introduction 7 8 9 10 Gear selector switch Auxiliary handle Quick-release chuck Depth stop Parts that can be replaced by the user: a) Auxiliary handle b) Depth stop If these parts become damaged or lost please contact the service centre for your country in order to replace them. For safety reasons, this applies especially to the auxiliary handle as this device may be used only with the auxiliary handle. Noise / Vibration data Values determined in accordance with EN 60745. The sound pressure level (A-weighted) of the device is typically 96 dB (A). The sound level while working can exceed 109 dB (A). [. . . ] Store the device indoors in an enclosed, dry place where it cannot be reached by children. To avoid danger to life from electric shock: Frequently check the condition of the device, mains lead and plug. Do not use the device if these kinds of parts are damaged. Always have any repairs carried out or replacement parts fitted at the service centre or by an electrical equipment repair specialist. A damaged device, mains lead or plug presents a serious danger to life from electric shock. J Have repairs carried out only by an electrician or your service centre. J Do not touch the mains lead if it becomes damaged or cut through while you are using the device. Pull the plug out of the mains socket immediately and have the device repaired by a suitably qualified person or at your service centre. J Do not operate the device if it is damp and do not use it in a damp environment. J If you use the device outdoors, always connect it through a residual current device (RCD) with a maximum trip current of 30 mA. If using an extension lead, always use one that is approved for outdoor use. The screwdriver bits used must be match the screw head. Set the switch 1 a to the drill symbol. Attaching the auxiliary handle For reasons of safety, this device must be used only with the auxiliary handle 8 in place and properly attached. It is essential that you note the following: if the drill becomes jammed, a very large torque can be generated (, , the force that the machine will exert to rotate about its own shaft"). j ttach the auxiliary handle 8 to the spindle A collar and fix in place by tightening the wing screw. This will help you to drill to the exact depth required. Operation Figures B - H show the various possible applications and uses. The mains voltage at the mains socket must match that shown on the rating plate on the device. Devices marked with 230 V can also be operated at 220 V. Inserting a tool into the chuck Caution!Before starting any tasks on the hammer drill, make sure that it is switched off and the mains plug is out of the socket. The RÖHM quick-release drill chuck allows you to exchange drills or other tools without using a special key etc. Switching on and off Switch on intermittent operation mode: j Press the On / Off switch 3 . Switch off intermittent operation mode: j Release the On / Off switch 3 . Switch on constant operation mode: j ress the On / Off switch 3 , and keep it P pressed, then press the locking button 4 . [. . . ] Tip: You will always find these two basic guidelines helpful: 1. Large drill diameter = lower speed whilst smaller drill diameter = higher speed 2. Hard material = lower speed electing S electing S drill / hammer drill action Caution!Only change the setting of the drill / hammer drill action switch after the tool has come to a standstill. [. . . ]