User manual PARKSIDE PWS 230 A1 ANGLE GRINDER

[. . . ] page Special safety advice for polishing . Page Special safety advice for working with wire brushes. The following pictograms are used in these operating instructions / on the device: Read instruction manual!Wear hearing protection, dust protection mask, protective glasses and protective gloves. [. . . ] Do not have the electrical power tool running while you are carrying it. Your clothing could become trapped by unintentional contact with the rotating attachment and the tool could be pulled into your body. Clean the ventilation slots on your electrical power tool regularly. the motor's fan draws dust into the housing. A build-up of metal dust could give rise to an electrical hazard. Never use the electrical power tool near inflammable materials. Do not use attachments that require the use of coolants. The use of water or other liquid coolants could result in electric shock. This causes the electrical power tool (if not controlled) to move in the opposite direction to the direction of rotation of the attachment at the point of constraint. If, for example, a grinding disc is pinched or snags in a workpiece, this can cause the edge of the grinding disc to penetrate the workpiece, become trapped there and either free itself or kickback. The grinding disc moves towards or away from the operator, depending on the direction of movement of the disc at the point of constraint. Flying pieces of wire can very easily penetrate thin clothing and / or skin. B) Use a guard, if recommended, but make sure that the wire brush does not come into contact with the guard. The diameters of disc brushes and cup brushes can increase due to contact pressure and centripetal forces. ½ Do not operate the device if the mains ½ Do not touch the mains lead if it becomes damaged or cut through while you are using the device. Pull the plug out of the mains socket immediately and have the device repaired by a suitably qualified person or at your service centre. Do not operate the device if it is damp and do not use it in a damp environment. If you use the device outdoors, always connect it through a residual current device (RCD) with a maximum trip current of 30 mA. If using an extension lead, always use one that is approved for outdoor use. Do not suspend or carry the device by the mains lead. Always work with the mains lead leading away from the rear of the device. Grinding discs must be carefully kept and handled in accordance with the manufacturer's instructions. [. . . ] Always use the angle grinder with the disc guard cover 5 in place. The disc guard cover must be securely attached to the angle grinder. Pull the mains plug out of the mains socket before you carry out any task on the device. Do not use sharp objects for cleaning the device. [. . . ]