User manual PARTNER GBV 325 REV 2

[. . . ] GB INSTRUCTION MANUAL IMPORTANT INFORMATION: Please read these instructions carefully and make sure you understand them before using this unit. Retain these instructions for future reference. FR MANUEL D'INSTRUCTIONS RENSEIGNEMENTS IMPORTANTS: Avant d'utiliser cet appareil, veuillez lire attentivement les instructions et assurez-vous de les avoir comprises. Conservez les instructions pour référence ultérieure. DE BETRIEBSANWEISUNG WICHTIGE INFORMATION: Lesen Sie diese Hinweise zur Handhabung des Geräts aufmerksam durch. Verwenden Sie es erst, wenn Sie sicher sind, daß Sie alle Anweisungen verstanden haben und gut aufbewahren. ES MANUAL DE INSTRUCCIONES INFORMACIÓN IMPORTANTE: Lea atentamente las instrucciones y asegúrese de entenderlas antes de utilizar esta aparato. [. . . ] Make sure elbow tube rib is aligned with the blower outlet groove. Turn knob clockwise to secure elbow tube. VACUUM TUBE ASSEMBLY 6. To remove the tubes, turn the bolt counterclockwise to loosen the tubes (do not remove nuts); remove the tubes. HIGH-SPEED NOZZLE ASSEMBLY When greater air speed is desired, use the high-speed nozzle. Align the slots on the nozzle with the tabs on the lower blower tube. Make sure air flows freely from the elbow tube into bag. If bag is kinked, the unit will not operate properly. 6. Align slanted end of lower vacuum tube as shown. Push lower vacuum tube into upper vacuum tube until the lower tube is securely seated in the upper tube (about 7 cm). Slanted end of lower vacuum tube 7. When vacuum tubes are fitted together, locate the label on the lower portion of the upper tube. Permanently assemble the two tubes together with the supplied screw. Lower Vacuum Tube Upper Vacuum Tube -- 6 -- OPERATION OPERATING POSITION Hearing Protection Hearing Protection BEFORE STARTING ENGINE Eye Protection WARNING: Be sure to read the fuel information in the safety rules before you begin. If you do not understand the safety rules, do not attempt to fuel your unit. Contact an authorized service dealer. FUELING ENGINE Blower Vacuum WARNING: Remove fuel cap slowly when refueling. This engine is certified to operate on unleaded petrol. Before operation, petrol must be mixed with a good quality 2-cycle air-cooled engine oil. We recommend Partner brand oil mixed at a ratio of 40:1 (2. 5%). A 40:1 ratio is obtained by mixing 5 liters of unleaded petrol with 0, 125 liter of oil. When mixing fuel, follow the instructions printed on the container. Always read and follow the safety rules before fueling your unit. IMPORTANT Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, empty the fuel system before storage for 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. [. . . ] Slowly pull the starter rope 8 to 10 times to distribute oil. S Replace spark plug with new one of recommended type and heat range. S Check entire unit for loose screws, nuts, and bolts. Replace any damaged, broken, or worn parts. [. . . ]