User manual PEAVEY 3D MIX PRO

[. . . ] Intended to alert the user to the presence of uninsulated Òdangerous voltageÓ within the productÕs enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: To reduce the risk of electric shock, do not remove cover. WARNING: To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. Before using this appliance, read the operating guide for further warnings. [. . . ] In typical operation, only the Cue switch from one channel should be activated at any given time. While one channel is playing, the other is usually in cue. Thus, you should find yourself pressing these buttons simultaneously and quite often throughout a show. This 100 mm stereo fader offers a smooth transition from infinite cut to +10 dB of boost. Use this control after your input gain and EQ have been set. Use the Stereo Level Meters to monitor the level from the Channel Fader. The signal level determined by the Channel Fader should stay consistent when crossfading from channel to channel. In standard practice, this control is generally set to 0 dB for nominal output. Each has a separate Level control but shares a common EQ. A phantom power of +15 VDC is supplied automatically for those mics that may require it. Care should be taken when using some wireless mics that cannot work with phantom power. Consult your wireless mic ownerÕs manual for proper operation. If phantom power cannot be used it is possible to modify your unit to defeat the phantom power. You may contact an authorized Peavey Service Center for more information. The Mic 1 and Mic 2 Level controls adjust the input level of their respective mics. turning the control fully clockwise (+45 dB) will result in maximum gain. Both level controls have a signal present LED Indicator which illuminates when the signal level exceeds -40 dBu. The Mute Switch defeats both mics so that they become inactive when mic silence is desired. This two-band (Hi and Low) active equalization affects only the Mic 1 and Mic 2 signals. the Hi EQ is centered at 10 kHz and the Low at 80 Hz. Both are of the shelving type and offer between 15 dB of gain and 15 dB of cut. Built into the EQ path is a 75 Hz 18 dB/oct low cut filter to reduce breath pops and handling noise. [. . . ] If this product is to be mounted in an equipment rack, rear support should be provided. Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably in susceptibility to noise-induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. GovernmentÕs Occupational and Health Administration (OSHA) has specified the following permissible noise level exposures: Duration Per Day In Hours 8 6 4 3 2 1 1/2 1 1/2 1/4 or less Sound Level dBA, Slow Response 90 92 95 97 100 102 105 110 115 According to OSHA, any exposure in excess of the above permissible limits could result in some hearing loss. [. . . ]