User manual PEAVEY 6505 PLUS

[. . . ] A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding plug. The wide blade or third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] We recommend that you read this manual carefully, paying close attention to any warnings or cautions. fEATURES: · Two distinct tube channels with footswitch control · Separate power amp controls (Resonance and Presence) for each channel · Metal three button footswitch with detachable 25' cable LINE CORD This line cord provides the AC power to the unit. connect the line cord to a properly grounded AC supply. Damage to the equipment may occur if improper line voltage is used. ) Never remove or cut the ground pin of the line cord plug. NOTE: FOR UK ONLY As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the terminals in your plug, proceed as follows: (1) The wire which is colored green and yellow must be connected to the terminal which is marked by the letter E, or by the earth symbol, or colored green or green and yellow. (2) The wire which is colored blue must be connected to the terminal which is marked with the letter N, or the color black. (3) The wire which is colored brown must be connected to the terminal which is marked with the letter L or the color red. It must be replaced with the same type and value in order to avoid damage to the equipment and to prevent voiding the warranty. If the amp repeatedly blows fuses, it should be taken to a qualified service center for repair. GROUND SWITCH This is a three-position, rocker type switch which, for most applications, should be operated in the center (zero) position. If hum or noise is noticed coming from the speaker enclosure(s) with the Ground Switch in the center position, place the Ground Switch to positive (+) or negative (-) to minimize hum. Should a hum/ noise problem continue, consult your authorized Peavey dealer, the Peavey factory, or a qualified service technician. If two enclosures of equal impedance are used, the switch should be set at one half of that value (e. , two 16 ohm enclosures: set switch to 8 ohms; two 8 ohm enclosures: set switch to 4 ohms). The footswitch cable should be plugged in before the amp is powered up. When the footswitch is plugged into the Remote Footswitch Jack, the Channel Select switch (14) must be pressed to the "in" position for remote selection of the Lead or Rhythm channel (right footswitch button). EFFECTS SEND/EFFECTS RETURN Signals are supplied to outboard effects or signal processing units by patching from the Effects Send (7) output into the outboard unit(s) and back into the Effects Return (8) input using shielded cables with 1/4" mono phone plugs. only non-gain effects devices (chorus , reverb , delay , etc. If footswitch is used, "Effects" must be selected (LED illuminated) for effects to work. [. . . ] The following specs are measured @ 1 kHz with the controls preset as follows: Low and High EQ @ 10 Mid EQ @ 0 Bright out Lead and Rhythm Posts @ 10 Presence and Resonance @ 0 dB Nominal levels with Pre Gains @ 5 Minimum levels with Pre Gains @ 10 Special 3-button unit with LED indicators (supplied) Channel select and reverb (20 Hz to 20 kHz unweighted) Greater than 63 dB below rated power Greater than 75 dB below rated power Features and specifications subject to change without notice. Due to the extreme high gain capabilities of the 6505+, it is imperative that you use a premium shielded instrument cable in order to minimize noise. What This Warranty Does Not Cover The Warranty does not cover: (1) damage caused by accident, misuse, abuse, improper installation or operation, rental, product modification or neglect; (2) damage occurring during shipment; (3) damage caused by repair or service performed by persons not authorized by Peavey; (4) products on which the serial number has been altered, defaced or removed; (5) products not purchased from an Authorized Peavey Dealer. Who This Warranty Protects This Warranty protects only the original retail purchaser of the product. [. . . ]