User manual PEAVEY ADRAIN VANDENBURG SIGNATURE MODEL

[. . . ] XR® 696 POWERED SOUND REINFORCEMENT MIXING CONSOLE Representing years of research and development in mixer engineering, the ADRAIN VANDENBURG SIGNATURE MODEL is a state-of-theart powered mixer packed with features. Incorporating DSP-based reverb/effects and delivering an awesome output of 600 Watts per channel program material (@ 4 Ohms), this compact, lightweight mixer is perfect for most any application. Two 9-band graphic EQs with FLS® Feedback Locating System · DDTTM speaker protection The standard channels (1 - 8) feature discrete low noise mic preamps with globally switched phantom power and 3-band EQ. Finally, there are three stereo channels (7 - 9) for tape, CD, or synth inputs. [. . . ] It is advisable to listen carefully to the output at the same time in order to determine the final setting. In Rotary Speaker setting, this adjusts the speed of the speaker rotation. cOLOR/TONE: Adjusts the high-frequency content of the effects signal. (While using a delay, this control adjusts the feedback or depth. ) EFX TO MON: Controls the amount of effects signal sent to the monitor mix. This control allows effects to be heard from the stage via the monitor. When feedback occurs, this system will automatically indicate the graphics slider to use to decrease that frequency band's gain in order to lessen or eliminate feedback. (NOTE: These LEDs illuminate with any audio signal, not just during feedback. ) GRAPHIC EQUALIZERS: These 9-band equalizers are fixed on one-octave centers. They are designed for 12 dB of cut and 12 dB boost. They are connected directly to their power amplifier inputs. This works well when you use the internal amps for monitor and external amps for Main. Only one patch cord is required to get the Main out to the external amp. In order to utilize both internal amps for Monitors then patch from Monitor Out into Right Power input. rIGHT OUTPUT: This 1/4" jack provides an output from the Right Main mix to supply external amp/speaker combinations. The level of this signal is determined by the Main Level control. POWER AMP INPUTS: Plugging into these jacks allows the user to go directly into the graphic equalizer, then into its respective power amplifier channel, and therefore bypass the other functions of the XR® 696. POWER LED: The power "on" LED indicator will light when the unit is powered. A/C POWER INLET: This is the receptacle for an IEC line cord, which provides AC power to the mixer/amplifier. Connect the line cord to this connector to provide power to the unit. Damage to the equipment may result if improper line voltage is used (see line voltage marking on unit). pOWER: The ADRAIN VANDENBURG SIGNATURE MODEL's main power switch. [. . . ] ) This product should be located so that its position does not interfere with its proper ventilation. It should not be placed flat against a wall or placed in a built-in enclosure that will impede the flow of cooling air. This product should not be placed near a source of heat such as a stove, radiator, or another heat producing amplifier. Connect only to a power supply of the type marked on the unit adjacent to the power supply cord. [. . . ]