User manual PEAVEY ALM-16 DATASHEET

[. . . ] Within one compact unit, we have packed feature after feature, each displaying the latest technology available. Here are several features you will certainly want to notice: · Two 9-band graphic EQs with FLS® Feedback Locating System® · DDTTM speaker protection The standard channels (1-4) feature discrete low noise mic preamps with globally switched phantom power, true high-impedance 1/4" mic inputs, low-cut filters, and three-band EQs. Two additional channels (5-6) offer balanced XLR mic inputs and 1/4" line level inputs. Finally, there are three stereo channels (7-9) for tape, CD, or synth inputs. [. . . ] When feedback occurs, this system will automatically indicate the graphics slider to use to decrease that frequency band's gain in order to lessen or eliminate feedback. (NOTE: These LEDs illuminate with any audio signal, not just during feedback. They are designed for 12 dB of cut and 12 dB boost. They are connected directly to their power amplifier inputs. SYSTEM MODE: This switch is used to configure the ALM-16 as either a stereo or dual mono amplifier. The ALM-16 is shipped from the factory in the default setting of Left Main to the upper EQ and Right to the lower EQ. When this switch is depressed it switches the lower EQ to (mono) PA Left + Right. The upper EQ then becomes the monitor signal only, creating an entire PA and monitor mixing system in one small, easy-to-carry package. And this change is accomplished without a single patch cord!This control also sets the monitor level going to the power amp when in Main/Monitor mode (see System Mode #24). This control sets the Main level going to the power amp when in Main/Monitor mode (see System Mode #24). The power on LED indicator (#33) will light when the unit is powered. FUSE: This is the main safety fuse for the AC line voltage. Only replace the fuse with one the exact same type and rating. By connecting a speaker cable to this jack and to a speaker cabinet, you complete the signal chain. You will notice that there are two pairs of jacks with another jack in the middle. The two pairs are your two (stereo) amp outputs. Two cabinets can be connected to each channel, as long as the combined impedance of the cabinets is not less than 4 ohms. BRIDGE OUTPUT: The bridge output of the ALM-16 allows the power of the left and right amplifiers to be combined into one mono output in applications where only one speaker will be used. To use the bridge output, the system mode switch must be in the Left/Right position. CAUTION: When using the bridge output no other speakers should be connected to the adjacent parallel speaker outputs. In addition, the minimum load for the ALM-16 in bridge mode is 8 ohms. [. . . ] Upon Peavey's receipt of these items: If the defect is remedial under these limited warranties and the other terms and conditions expressed herein have been complied with, Peavey will provide the necessary warranty service to repair or replace the product and will return it, FREIGHT COLLECT, to you, the purchaser. peavey's liability to the purchaser for damages from any cause whatsoever and regardless of the form of action , including negligence , is limited to the actual damages up to the greater of $500. 00 or an amount equal to the purchase price of the product that caused the damage or that is the subject of or is directly related to the cause of action Such purchase price will be that in effect for the specific product when the cause of action arose. This limitation of liability will not apply to claims for personal injury or damage to real property or tangible personal property allegedly caused by Peavey's negligence, Peavey does not assume liability for personal injury or property damage arising out of or caused by a non-Peavey alteration or attachment, nor does Peavey assume any responsibility for damage to interconnected non-Peavey equipment that may result from the normal functioning and maintenance of the Peavey equipment. [. . . ]