User manual PEAVEY AM 4

[. . . ] Refer servicing to qualified service personnel. WARNING: To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. Before using this appliance, read the operating guide for further warnings. Este símbolo tiene el propósito, de alertar al usuario de la presencia de "(voltaje) peligroso" que no tiene aislamiento dentro de la caja del producto que puede tener una magnitud suficiente como para constituir riesgo de corrientazo. Este símbolo tiene el propósito de alertar al usario de la presencia de instruccones importantes sobre la operación y mantenimiento en la literatura que viene con el producto. [. . . ] The Left/Mono input supplies signal to both the Left and Right channels (if there is nothing inserted to the right input jack) through the Level control (#4). In Left/Right mode the signal will go to the Left Speaker Output (and Right Speaker Output if nothing is inserted to the right input jack). In Mon/Main mode the signal is combined with the Right and placed on the Main Speaker Output. 13 12 10 CHANNEL 9 14. TAPE IN: This stereo RCA phono jack accepts a stereo input (nominally -10 dBV) from the output of a tape deck or CD player and places it on the Left and Right channels as well as the Monitor Mix. TAPE OUT: This stereo RCA phono jack provides a signal for the recording inputs of a stereo tape deck. CAUTION: DO NOT HOOK THE TAPE IN AND TAPE OUT TO THE INPUT AND OUTPUT OF THE SAME DECK. DOING SO WILL FORM A LOOP CAUSING SEVERE FEEDBACK. USE SEPERATE DECKS FOR RECORDING AND PLAYBACK. 14 MASTER SECTION: 16. EFFECTS PEAK LED: Illuminates to indicate -6 dB of headroom before the signals being sent to the effects circuit are clipped. Ideally, you would want this LED to light only occassionally if at all. An occassional blink indicates that you have the levels at an optimum setting. MONITOR LEVEL: Sets the overall level of the monitor signal that is sent to the Monitor Output Jack. This control also sets the monitor level going to the power amp when in Main/Monitor mode (see System Mode #24). 6 17 18 19 20 21 16 33 23 22 25 24 22 26 23 27 28 29 30 31 32 26. MAIN LEVEL: This is the master level control for the main mix sent to the Left/Mono and Right output jacks. This control sets the Main level going to the power amp when in Main/Monitor mode (see System Mode #24). A good starting position for this control is the center detent position (12:00). PHANTOM POWER SWITCH: Applies 48 V DC voltage to all input XLR connectors to power microphones that require it. When phantom power is switched on, make sure that any channel you are plugging a mic into is turned down in both the main and monitor mixes. Otherwise, there will be a loud pop in the PA. It is best to plug all mics into their respective channels with the phantom power switched off. Damage to the equipment may result if improper line voltage is used (see line voltage marking on unit). POWER: The mixer's main power switch. [. . . ] Connect only to a power supply of the type marked on the unit adJacent to the power supply cord. Never break off the ground pin on the power supply cord. For more information on grounding, write for our free booklet "Shock Hazard and Grounding. " 7. Power supply cords should always be handled carefully. [. . . ]