User manual PEAVEY AUTOGRAPH

[. . . ] Refer servicing to qualified service personnel. WARNING: To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. Before using this appliance, read the operating guide for further warnings. Este símbolo tiene el propósito, de alertar al usuario de la presencia de "(voltaje) peligroso" sin aislamiento dentro de la caja del producto y que puede tener una magnitud suficiente como para constituir riesgo de descarga eléctrica. Este símbolo tiene el propósito de alertar al usario de la presencia de instruccones importantes sobre la operación y mantenimiento en la información que viene con el producto. [. . . ] Both outputs can be used simultaneously. The MIC/LINE switch determines whether the balanced output is nominally at microphone level or line level. For driving power amplifiers, this switch should be in the LINE position. NOTE: This applies ONLY to the balanced output, NOT the LINE OUT. Positive Negative Shield AND. . . . OR. . . . Balanced Line or Mic Output Negative Positive Figure 3. Master Output Connections Unbalanced Line Output The LINK feature provides functionality to combine multiple Automix 4's into a larger system. The link circuitry is designed to allow for separate combine circuits for the audio and control buses. When multiple units are combined, and both the audio and control busses are linked, the gain management feature is unified between all units, thereby providing a larger automatic mixer. The main output would be derived from the master unit, while secondary outputs from the slaves could be used for secondary or monitor feeds. The LINK switch determines whether the Automix 4 is a master or slave in the system. For best results, only one master should be used in a typical system. For proper operation, all SLAVE units MUST have both buses linked to the MASTER unit. Adjust the Channel Gain Control to its minimum position, or fully counterclockwise for the Channel you are working on. It is important to use a properly sized Phillips head screwdriver for this adjustment. Take care not to force the control, or damage may occur. Figure 7. Channels 3 and 4 do not include the Priority Control) Apply an audio signal to the input by speaking into a microphone at a nominal level. While monitoring the master Level Meters, slowly adjust the Gain Control clockwise while audio is present. Keep turning the control until the Level Meters are indicating nominal level at the 0dB LED on the meter. In addition, the Channel Clip LED should not be red. This LED illuminates red when the signal level is at clipping. Speak loudly into the microphone and watch the action of the CLIP LED on the Master Meter and the input Channel. It is OK for these LED's to flash red on occasion. If they stay red however, the Gain Control is set too high. [. . . ] Meridian MS 39301 USA Phone: 601-483-5376 Fax: 601-486-1678 Website: http://aa. peavey. com Warranty Registration Please take a few minutes and fill out the warranty registration card for your Automix 4. Although your warranty is valid without the registration, the information you provide with the form is crucial to our support group. It enables us to provide better service and customer support, and to keep you informed of new product updates. Refer to the warranty statement on the back page of this manual for details about what your warranty includes and what the limitations are. Page 20 http://aa. peavey. com copyright 2000 All Rights Reserved Specifications Specifications MECHANICAL Dimensions (H x W x D) Weight Mounting Connections 1. 75" x 19" x 9. 38" (45 mm x 483 mm x 238 mm) 7. 5 lbs. , 3. 4 kg Single EIA Space Rack Mount Removable "Euro" Connectors for single Channel audio inputs, outputs and bus link. [. . . ]