User manual PEAVEY BACKSTAGE 110

[. . . ] Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point they exit from the apparatus. Note for UK only: If the colors of the wires in the mains lead of this unit do not correspond with the terminals in your plug, proceed as follows: a) The wire that is colored green and yellow must be connected to the terminal that is marked by the letter E, the earth symbol, colored green or colored green and yellow. B) The wire that is colored blue must be connected to the terminal that is marked with the letter N or the color black. C) The wire that is colored brown must be connected to the terminal that is marked with the letter L or the color red. [. . . ] only use attachments/accessories provided by the manufacturer. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. Unplug this apparatus during lightning storms or when unused for long periods of time. refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. Write for our free booklet "Shock Hazard and Grounding. " Connect only to a power supply of the type marked on the unit adjacent to the power supply cord. If this product is to be mounted in an equipment rack, rear support should be provided. Exposure to extremely high noise levels may cause a permanent hearing loss. This control allows you to dial in the amount of high-end for your guitar. This control adds bottom-end to your sound. Use to fatten up the sound of your guitar. This standard 1/4" input jack allows you to connect a tape or CD player to your Backstage and play along. This standard 1/4" output jack allows you to connect standard headphones to the Backstage. When headphones are connected to the Backstage, the speaker is automatically turned off. This LED illuminates when power is supplied to the Backstage. This two-way rocker switch applies power to the unit when placed in the ON position. 10 Watts RMS into 8 Ohms @ 10% THD, 1 kHz, 120 VAC line Domestic: 26 Watts, 60 Hz, 120 VAC Export: 26 Watts, 50/60 Hz, 230­240 VAC (Clean channel, 20 Hz­20 kHz unweighted) Greater than 70 dB below rated power The following specifications are measured @ 1 kHz with the controls preset as follows: Impedance: High Z, 22 k Ohms Nominal Input Level: -4 dB, 600 mV RMS Nominal Output Level: 25 mV into 4 Ohms (Disconnects internal speaker when used) 10 Watts RMS into 8 Ohms @ 10% THD, 1 kHz, 120 VAC line Domestic: 26 Watts, 60 Hz, 120 VAC Export: 26 Watts, 50/60 Hz, 230­240 VAC (Clean channel, 20 Hz­20 kHz unweighted) Greater than 70 dB below rated power The following specifications are measured @ 1 kHz with the controls preset as follows: Impedance: High Z, 22 k Ohms Nominal Input Level: -4 dB, 600 mV RMS Nominal Output Level: 25 mV into 4 Ohms (Disconnects internal speaker when used) This standard 1/4" input jack allows you to connect a tape or CD player to your Backstage and play along. What This Warranty Does Not Cover The Warranty does not cover: (1) damage caused by accident, misuse, abuse, improper installation or operation, rental, product modification or neglect; (2) damage occurring during shipment; (3) damage caused by repair or service performed by persons not authorized by Peavey; (4) products on which the serial number has been altered, defaced or removed; (5) products not purchased from an Authorized Peavey Dealer. [. . . ] What This Warranty Does Not Cover The Warranty does not cover: (1) damage caused by accident, misuse, abuse, improper installation or operation, rental, product modification or neglect; (2) damage occurring during shipment; (3) damage caused by repair or service performed by persons not authorized by Peavey; (4) products on which the serial number has been altered, defaced or removed; (5) products not purchased from an Authorized Peavey Dealer. Who This Warranty Protects This Warranty protects only the original retail purchaser of the product. What Peavey Will Do We will repair or replace (at Peavey's discretion) products covered by warranty at no charge for labor or materials. If the product or component must be shipped to Peavey for warranty service, the consumer must pay initial shipping charges. [. . . ]