User manual PEAVEY BAM 210

[. . . ] For more information on other great Peavey products, go to your local Peavey dealer or online at www. Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: To reduce the risk of electric shock, do not remove cover. WARNING: To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. [. . . ] In the chromatic mode the two LEDs that a note falls between will light if the note being tracked is not a note in standard bass tuning. Once a note is being tracked, the yellow and red LEDs function similarly to a strobe tuner, that is they light sequentially to form a ring. counterclockwise movement of the ring indicates the note being tracked is flat; clockwise movement indicates it is sharp. The rotation speed will decrease as the note comes closer to tune, and all indicators will illuminate (no movement) when the note reaches correct pitch. (42) REMOTE CABLE CONNECTOR This 8-pin DIN connector transmits and receives MIDI commands to and from the MIDI IN / FOOTSWITCH (28). Certain functions, such as the tuner, are also communicated through this connection. Only the Peavey 8-pin MIDI/Communication cable (included) should be used for this connection. HIDDEN POWER FEATURES The BAM lets you do most of what you need via the standard controls on the front panel and footswitch. However, there are other parameters under the hood that you can get to if you're willing to dig a little deeper. By holding the USER button for more than a second (and continuing to hold), you can access additional preset parameters. Doing the same with the STORE button accesses global preference parameters. The following table and subsequent text shows what parameters are available. BOOST/FX SETTINGS COPYING The boost function allows you to have two complete settings (per preset) for the pre gain, post gain, and three-band EQ. When creating a preset, you will typically build your non-boost sound (boost LED off on the PFC4B), then want to modify it for the boost. Well, the settings will usually be very different, and sychronizinig them manually is a bit of a pain. So, you can press the USER button for one second (and continue to hold, which puts the amp into Patch Tweak mode, see below), and hit the boost footswitch. This will copy the five parameters from the non-boost to the boost slots. (If you were boosted in the first place, the copy would go the other way - it goes from where you were to where you're switching. ) This also works with the effects knobs, but since there are only two, it's not much of a problem to tweak them manually. Analog Overdrive Enable - Enabled or disabled by amp model selection, after which this can override. Tweeter Enable - Enabled or disabled by cabinet model selection, after which this can override. Channel messages will be sent with this channel, and will be ignored upon receive unless on this channel. [. . . ] Never break off the ground pin on the power supply cord. For more information on grounding, write for our free booklet "Shock Hazard and Grounding. " Power supply cords should always be handled carefully. Never walk on or place equipment on power supply cords. [. . . ]