User manual PEAVEY BANDIT 112

[. . . ] Congratulations on your purchase of a Peavey TransTube® Series instrument amplifier. Whether you are a beginner or seasoned pro, you could not have found a more practical, feature-packed amplifier. Peavey's patented TransTube circuitry has moved forward into the second generation of products, leading the industry in tube emulation. There is no other solid-state amp that more closely replicates the characteristics of a tube amp. [. . . ] Clean EQ The TransTube EQ featured on the Clean channel of your amp offers 3-band tone adjustment. Each EQ control is passive (does not add gain) and has a frequency range dependent on the position of the Modern/Vintage Switch. Reducing the control to the "0" position (fully counterclockwise) introduces maximum cut in level for the particular band. Low, Mid and High bands are available for adjustment. This control is often used to adjust the amount of distortion present in the Lead channel. modern/Vintage/High Gain- Switch This switch changes both the gain and voicing of the Lead channel. Selecting the MODERN setting increases the overall gain and notches (cuts) the mid frequencies to establish a modern tone often associated with Hard Rock and Metal styles. This creates a tighter response at lower Pre Gain settings or an "over the top" sound at higher Pre Gain settings. Experiment with this switch setting while adjusting the Lead EQ (12) to help you obtain your desired tone. You may refer to the Recommended Settings on page 11 for some creative starting points. Lead EQ The TransTube EQ featured on the Lead channel of your amp offers 3-band tone adjustment. Effects Loop This pair of mono 1/4" jacks supply an effects SEND and RETURN path for the preamp signal. connect the SEND jack to the input of external , low-level , signal processing equipment (effects). Return the signal from your external equipment to the RETURN jack. This is known as an Effects Loop since the signal exits your amp (send) and loops (return) back to it. On the Bandit 112, the effects loop can be swapped in and out of the signal path using the supplied Remote Switch (18). This jack disconnects internal speaker when used on Studio Pro 112 Preamp Out The Preamp Output can be used to route the preamp signal to a mixing console, tape recorder, etc. Using a shielded instrument cable with mono 1/4" plugs, connect the Preamp Output to the input of your outboard equipment. This patch will not affect the normal operation of your amplifier. Power Amp In Connect line level signals from external equipment to this input. Inserting a plug into this mono 1/4" jack will prevent the TransTube preamp signal from being sent to the amplifier. In this configuration, the power amp only amplifies the signal introduced at the Power Amp In jack. [. . . ] The following specs are measured @ 1 kHz with the controls preset as follows: Channel Select, Clean Clean Mode Switch, Modern Low and High @ 10 Mid @ 0 Lead Pre and Post Gain @ 10 Lead Mode Switch, Vintage Reverb @ 0 Nominal Levels are with Clean Volume @ 5 Minimum Levels are with Clean Volume @ 10 (20 Hz to 20 kHz unweighted) Greater than 78 dB below rated power Special Low, Mid, and High passive type EQ Modern/Vintage switch (Clean): Two distinct EQ voicings Vintage/Modern/High Gain switch (Lead): Three different EQ and Gain voicings Presence: +6 dB @ 5 kHz Push Resonance: +6 dB @ resonant frequency of cabinet Specifications subject to change without notice. Commutateur à distance Cette prise accepte l'interrupteur à distance au pied de votre ampli. WARNING: When using electric products, basic cautions should always be followed, including the following: 1. For example, near or in a bathtub, swimming pool, sink, wet basement, etc. [. . . ]