User manual PEAVEY BASIC 40

[. . . ] Before using this appliance, read the operating guide for further warnings. WARNING: When using electrical products, basic cautions should always be followed, including the following: Do not use this apparatus near water. Do not block any of the ventilation openings. install in accordance with manufacturer's instructions. [. . . ] (3) The wire that is colored brown must be connected to the terminal that is marked with the letter L or the color red. (2) REMOTE SWITCH CONNECTOR This 8-pin DIN connector is provided for the connection of the PFC 3 footswitch (not included). The footswitch cable should be connected before the amp is powered up. This stereo jack allows signal to flow to both sides of any stereo headset. A monaural headset may be used, but it is not recommened. Input jack will accept signals from all types of guitar pickups. Be sure to use a high quality shielded instrument cable to connect the guitar to the amplifier. Controls the volume level of the Clean channel and is not affected by the Lead, Pre or Post Gain controls. The Pre Gain can be used to control the distortion level in the Lead channel. To obtain more distortion simply increase the Pre Gain and set the Post Gain (9) to the desired volume level. The final level adjustment should be made after the desired sound has been achieved. Their corresponding LEDs indicate which preset is active. Once desired settings are achieved utilizing the effects controls on the front panel, double-click one of the Preset switches (15, 23, or 25) to store the settings. To return to the last saved settings for a Preset, press the desired Preset switch once. For a detailed explanation on creating and storing presets, refer to the TWEAK FEATURES section of this manual on the following page. In addition to the adjustments described in the EFX ADJ PARAMETERS section of this manual, additional tweaks may be made to customize effects to user preference. Tweaks are made by pressing and holding the EFX ADJUST (14) control while simultaneously rotating the REVERB (15) control. The EFX ADJUST control must be pressed for at least one second to enter Tweak Mode. Reverb setting will not be affected while in Tweak Mode. The LED ring surrounding the control will now reflect the value of the effect being tweaked. As in standard parameter changes, the effect being tweaked will be the active effect as indicated by the LED adjacent to the effect name. To recover the factory settings for both Standard and Tweak Modes, press the EFX ADJUST (14) control and hold for one second to enter Tweak Mode, then press the DELAY (16) control. [. . . ] RECOMMENDED SETTINGS NOTE: Tone settings given are general recommendation and will vary depending on make of guitar and type of pickup. Specifications are subject to change without notice. This block diagram shows signal flow within the unit. In order to thoroughly understand the unit's functions, please study the block diagram carefully POWER AMP SECTION: Rated power and load: 40 Watts (RMS) into 6 Ohms Power @ clipping (typically): (5% THD, 1 kHz, 120 VAC line) 35 Watts (RMS) into 6 Ohms Total harmonic distortion: Less than 0. [. . . ]