User manual PEAVEY BASIC 50

[. . . ] Before using this appliance, read the operating guide for further warnings. WARNING: When using electrical products, basic cautions should always be followed, including the following: Do not use this apparatus near water. Do not block any of the ventilation openings. install in accordance with manufacturer's instructions. [. . . ] 0 Keep out Serial Sticker area The footswitch cable should be connected before the amp is powered up. 3V RMS) when "out" and 0 dBV (1 V RMS) when "in". PREAMP OUT The preamp out can be used to route the amplified signal from the preamp to a mixing console, tape recorder, etc. Connect the preamp output to line-level inputs of other equipment using high quality shielded cable. This patch does not affect operation of the amplifier. pOWER AMP IN Used to connect line-level signals to the power amplifier section. Connect the power amp input to line-level output of other equipment using high quality shielded cable. This patch disconnects the preamp section from the power amp section. A higher damping factor (TIGHT) reduces cone vibration more quickly than a lower damping factor (LOOSE). This switch works much like the Resonance and Presence controls found on other Peavey amps, if they were to be turned simultaneously. If the Damping switch is changed, the volume level of the amp will also change and may require re-adjustment of the volume. sWITCH 3 (35) toggles between two reverb and delay settings. As with effects settings, this switch may be used as an on/off for reverb and delay. Both functions change simultaneously when this switch is depressed. In addition to the adjustments described in the EFX ADJ PARAMETERS section of this manual, additional tweaks may be made to customize effects to user preference. Tweaks are made by pressing and holding the EFX ADJUST (12) control while simultaneously rotating the REVERB (13) control. The EFX ADJUST control must be pressed for at least one second to enter Tweak Mode. Reverb setting will not be affected while in Tweak Mode. The LED ring surrounding the control will now reflect the value of the effect being tweaked. As in standard parameter changes, the effect being tweaked will be the active effect as indicated by the LED adjacent to the effect name. To recover the factory settings for both Standard and Tweak Modes, press the EFX ADJUST (12) control and hold for one second to enter Tweak Mode, then press the DELAY (14) control. CREATING AND STORING A CUSTOM PRESET The following steps explain the creation and storage of two different effects/settings, as well as two different settings for Delay/Reverb. [. . . ] Disconnect unit from power supply before cleaning. Care should be taken so that objects do not fall and liquids are not spilled into the unit through the ventilation holes or any other openings. This unit should be checked by a qualified service technician if: a. Anything has fallen or been spilled into the unit. [. . . ]