User manual PEAVEY CLASSIC 30

[. . . ] The final level adjustment should be made after the desired sound has been achieved. This input produces enhanced high frequency response (treble), similar to a bright switch when compared to the normal input. If the amp repeatedly blows fuses, it should be taken to a qualified service center for repair. Three position rocker-type switch which, in most applications, should be operated in its center or zero position. [. . . ] If this situation arises, position the ground switch to either positive or negative ( + or -) or until the noise is minimized. NOTE: Should the noise problem continue, consult your Authorized Peavey Dealer, the Peavey Factory, or a qualified service technician. When both jacks are engaged, amplifier impedance is 8 ohms. When using remote footswitch, always insert the plug fully (second click) to ensure proper operation. The following specs are measured @ 1 kHz with the controls preset as follows: (5% THD, 1 kHz, 120 V AC line) 50 W RMS into 16 or 8 ohms (Bias must be reduced to measure) Pre & Post (lead) @ 0 Reverb Level @ 0 Bass & Treble EQ @ 12 Middle EQ @ 0 Master Volume @ 12 Presence @ 6 Nominal level is with Input Gain @ 6 Minimum levels is with Input G a i n @ 12 Greater than 80 dB below rated power Tone settings given are general and will vary according to type of guitar, type and guages of strings, type of pickup and even type of pick. Personal taste, playing style, and type of music greatly contribute to desired tonahty. STANDBY SWITCH (Interruptor de condicih de espera) (2) Este interruptor le permite a su aparato estar en condition de"espera" o la condition de active. Afin d'assurer un bon fonctionnement lors de l'utilisation de l'interrupteur au pied, inserez la fiche Zt fond jusquau second cran (au second clic). 00 or an amount equal to the purchase price of the product that caused the damage or that IS the subject of or IS directly related to the cause of action. Such purchase price will be that in effect for the specific product when the cause of action arose. Never walk or place equipment on power supply cords. Periodically check cords for cuts or signs of stress, especially at the plug and the point where the cord exits the unit. The power supply cord should be unplugged when the unit is to be unused for long periods of time. Metal parts can be cleaned with a damp rag. The vinyl covering used on some units can be cleaned with a damp rag, or an ammonia-based household cleaner if necessary. Disconnect unit from power supply before cleaning. If this product is to be mounted in an equipment rack, rear support should be provided. Care should be taken so that objects do not fall and liquids are not spilled into the unit through the ventilation holes or any other openings. This unit should be checked by a qualified service technician if a. Anything has fallen or been spilled into the unit. [. . . ] The unit has been dropped or the enclosure damaged. The user should not attempt to service this equipment. All service work should be done by a qualified service technician. This product should be used only with a cart or stand that is recommended by Peavey Electronics. [. . . ]