User manual PEAVEY CS 800H

[. . . ] For more information on other great Peavey products, go to your local Peavey dealer or online at www. Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: To reduce the risk of electric shock, do not remove cover. WARNING: To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. [. . . ] This LED is at the bottom of the bar graph display and lights when its channel produces an output signal of greater than 2 Volts RMS or 50 mV input with a 0 dB attenuation of the front panel knobs. It is useful in determining whether a signal is reaching and being amplified by the amplifier. The DC LED lights to indicate that the channel's output relay is open, disconnecting the speaker(s) when the amplifier senses a DC voltage or subsonic high level signal at its output. Once the channel temperature has returned to safe operating conditions the LED will turn off and the speaker(s) will be reconnected. Illuminates when DDT Compression is taking place. With the Enable/Defeat switch in the Defeat position, the LED indicates when clipping distortion is occuring. The ACTIVE LED indicates that its channel's output relay is closed and the channel is operational. Cool air enters the amplifier here and exhausts through the rear vents. Any restriction or blockage could cause excessive operation temperatures and the unit could shut down. These vents provide an exhaust path for the hot air from the heatsinks. Any restriction or blockage could cause excessive opertion temperature and the unit could shut down. This switch is used to either Enable or Defeat the DDT compressor. It is recommended to leave the DDT compression enabled at all times to protect your speakers from damage square waves. This input features a combo connector that will accept a standard three-pin male XLR, 1/4" (6. The CS 800H is equipped with two independent, two-way crossovers adjustable from 40 Hz to 300 Hz. These crossover frequencies are appropriate for use with a subwoofer system. the output of these crossovers is selected by the Amp Function switch and connected to the corresponding amplifier channel. Frequencies above the knob setting will be connected to the corresponding channel when the Amp Function switch is in the HIGH PASS position. Frequencies below the knob setting will be connected to the corresponding channel when the Amp Function switch is in the LOW PASS position. the threshold of compression is clipping itself and no specific threshold control is used. This technique effectively utilizes every watt available for the power amplifier to reproduce the signal while at the same time minimizes clipping and distortion, and thus significantly reduces the potential of loudspeaker degradation and damage. The CS 800H features innovative circuitry that allows safe operation into any load. [. . . ] 0 V @ rated power, 4 Ohms, 1 kHz Input impedance: Input attenuator set @ FCW 20 k Ohms, balanced Cooling: One front panel, temperature dependant, variable speed DC fan Controls: Two front panel attenuators, rear panel mode switch, rear panel DDT defeat switch, function switch per channel, adjustable low cut filter per channel, low cut filter bypass switch per channel, adjustable subwoofer crossover per channel Indicator LEDs: Two DDT, two active status, two DC protect, two over-temperature, two ten-segment signal displays Protection: Clipping, short-circuit, thermal overload, DC, turn-on burst, incorrect loads Connectors: Combination XLR and 1/4" (6. Steel with cast aluminum front panel and cast handles Dimensions (H x W x D): 3. 6 kg) 2 Ohms stereo mode and 4 Ohms bridge mode power is time limited by magnetic circuit breaker Power Loss into 8 Ohms (%) . Connect the loudspeaker across the two RED binding posts on the amplifier outputs 9 . [. . . ]