User manual PEAVEY DPM C8 ADDENDUM SOFTWARE V2.0

[. . . ] Capable of over 130 dB peak SPLs, this system can pump out a huge amount of sound. The enclosure utilizes highimpact polypropylene in an injectionmolded plastic trapezoidal form with a coated, perforated metal grille for a cosmetically elegant yet durable powered speaker system. This two-way powered system is comprised of an 800 Watt dynamic peak power amplifier driving a 12" BWX Black Widow woofer (1208-4) with a KevlarTM impregnated cone, with surround and dust cap specially treated for excellent environmental stability. [. . . ] A 200 Watt peak dynamic power amplifier drives the RX22 compression driver and features a 2" titanium diaphragm with Radialinear Planar Phase Correction in the phase plug (US Patent #6064745). A Quadratic Throat Geometry constant directivity horn (US Patent #6059069) with a coverage pattern of 90° by 45° is molded integrally into the enclosure. The Quadra 12P houses one combo female XLR, a 1/4" RTS phone jack and one male XLR in its preamp, all connected in parallel. A separate, switchable female XLR microphone input is also provided. The power amplifiers are low distortion units providing 400 W RMS into the nominal 4 Ohm load of the woofer and 100 W RMS into the nominal 6 Ohm load of the tweeter, both selected for their reliability and superb musical performance capability. Both amplifiers feature our patented SPS compression, which virtually eliminates audible power amplifier clipping. Electroacoustic crossover frequency: 1, 800 Hz Crossover type: Internal, electronic two-way crossover with CD horn EQ, level matching, active bass boost and subsonic filtering. The horn is spatially aligned with the woofer, eliminating the need for phase alignment or signal time delay. Crossover slopes: 18 dB/octave (third order) low pass and 18 dB/octave (third order) high pass, both with staggered poles and driver EQ. A handgrip is molded into each side of the woofer and on the top rear edge. A vinyl-coated, perforated metal grille provides woofer protection. The cabinet incorporates four tall, sturdy rubber feet for floor standing use and four mounting-point inserts on the top and bottom, each for flying use. The outside dimensions are 2311/16" high by 17-13/16" wide by 13-3/4" deep, and the unit weighs 55 lbs. Power requirements: maximum 660 Watts, nominal 180 Watts, 120VAC, 60 Hz domestic and 240 VAC, 50 Hz (European). 3 + 2 YEAR LIMITED WARRANTY NOTE: For details, refer to the warranty statement. Copies of this statement may be obtained by contacting Peavey Electronics Corporation, P. O. Box 2898, Meridian, Mississippi 39301-2898. Multiple molded-in handles provide easy transport, while multiple mounting points on top and bottom for the Peavey Versamount70 and a molded-in stand adapter allow maximum utility. [. . . ] Copies of this statement may be obtained by contacting Peavey Electronics Corporation, P. O. Box 2898, Meridian, Mississippi 39301-2898. Multiple molded-in handles provide easy transport, while multiple mounting points on top and bottom for the Peavey Versamount70 and a molded-in stand adapter allow maximum utility. ARCHITECTURAL AND ENGINEERING SPECIFICATIONS This powered loudspeaker system has a frequency response from 62 Hz to 18 kHz. [. . . ]