User manual PEAVEY DPM SX II ERRATA ADDENDUM

[. . . ] Excessive boost at very low frequencies could also limit overall system headroom. Engaging the 40 Hz low-cut filter is the best way to avoid these problems. NOTE: Superb tonality, absence of feedback, and great-sounding systems may not be possible with any graphic equalizer. All other system components must be of high quality and designed for the application. [. . . ] When this switch is engaged, the signal is routed from INPUT (10 and 11) though the low-cut filter to output (8 and 9). POWER This 2-position rocker switch applies mains power to the unit when in the ON position. The adjacent green LED indicates mains power activation. Never break off the ground pin on any equipment. If the outlet used does not have a ground pin, a suitable grounding adapter should be used and the third wire should be grounded properly. To prevent the risk of shock or fire hazard, always be sure that the equalizer and all associated equipment is properly grounded. NOTE: FOR UK ONLY If the colors of the wires in the mains lead of this unit do not correspond with the colored markings identifying the terminals in your plug, proceed as follows: (1) The wire that is colored green and yellow must be connected to the terminal that is marked by the letter E, the earth symbol, colored green, or colored green and yellow. (2) The wire that is colored blue must be connected to the terminal that is marked with the letter N or the color black. (3) The wire that is colored brown must be connected to the terminal that lis marked with the letter L or the color red. TRS BALANCED OUTPUT These 1/4" Tip/Ring/Sleeve (stereo) jacks provide balanced output when used with TRS connectors and 2-conductor shielded cables. When used with a mono 1/4" (TS) phone plug, the output is unbalanced. If you have any questions about this warranty or service received or if you need assistance in locating an Authorized Service Center, please contact the Peavey International Service Center at (601) 483-5365 / Peavey Canada Ltd. Features and specifications subject to change without notice. WARNING: When using electric products, basic cautions should always be followed, including the following: 1. Read all safety and operating instructions before using this product. All safety and operating instructions should be retained for future reference. This product should not be used near water (i. ) This product should be located so that its position does not interfere with its proper ventilation. It should not be placed flat against a wall or placed in a built-in enclosure that will impede the flow of cooling air. This product should not be placed near a source of heat such as a stove, radiator, or another heat producing amplifier. Connect only to a power supply of the type marked on the unit adjacent to the power supply cord. Never break off the ground pin on the power supply cord. [. . . ] This unit should be checked by a qualified service technician if: a. Anything has fallen or been spilled into the unit. The unit has been dropped or the enclosure damaged. The user should not attempt to service this equipment. [. . . ]