User manual PEAVEY DPM V3

[. . . ] ATTENTION: Risques de choc électrique -- NE PAS OUVRIR!ATTENTION: Afin de réduire le risque de choc électrique, ne pas enlever le couvercle. Il ne se trouve à l'intérieur aucune pièce pouvant être reparée par l'utilisateur. Confiez I'entretien et la réparation de l'appareil à un réparateur Peavey agréé. [. . . ] The wide blade or third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point they exit from the apparatus. Note for UK only: If the colors of the wires in the mains lead of this unit do not correspond with the terminals in your plug, proceed as follows: a) The wire that is colored green and yellow must be connected to the terminal that is marked by the letter E, the earth symbol, colored green or colored green and yellow. b) The wire that is colored blue must be connected to the terminal that is marked with the letter N or the color black. c) The wire that is colored brown must be connected to the terminal that is marked with the letter L or the color red. Only use attachments/accessories provided by the manufacturer. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. Unplug this apparatus during lightning storms or when unused for long periods of time. Refer all servicing to qualified service personnel. NOTE: Superb tonality, absence of feedback and great-sounding systems may not be attainable regardless of the equalizer used; all system components must be of high quality and designed for the application. No amount of equalization will correct poor acoustics, poor microphone/speaker arrangement or the response curve of a poor loudspeaker. Front Panel 4 1 2 6 5 3 FEATURES AND CONTROLS (1) OUTPUT LEVEL LED METER This LED array indicates output level from ­12 dB to +12 dB. (2) GAIN This calibrated, detented control regulates overall gain of the EQUALIZER section (3). Total gain throughout the signal chain can be maintained by recovering lost signal gain at this point. The equalization process may result in noticeable signal loss. To compensate for this loss, engage the BYPASS (5) switch and compare the signal level with that of the equalized level. Increase the GAIN control until the equalized level approximates that of the bypassed level. (3) EQUALIZER SECTION These calibrated, detented controls adjust the amount of cut or boost within their respective 5 frequency bands. They are adjustable within ±12 dB, or ±6dB for improved precision. (4) LOW CUT FILTER This switch activates the low cut filter, which rejects frequencies below 40 Hz. Frequency rolloff is 24 dB per octave with the switch engaged. [. . . ] Note: All specifications measured at 0 dBu (0. 775 Volts RMS) input, unbalanced output, sliders at center position and all switches disengaged unless otherwise stated. OR (2) Ship the defective item, prepaid, to Peavey Electronics Corporation, International Service Center, 412 Highway 11 & 80 East, Meridian, MS 39301 or Peavey Canada Ltd. , 95 Shields Court, Markham, Ontario, Canada L3R 9T5. Include a detailed description of the problem, together with a copy of your sales receipt or other proof of date of purchase as evidence of warranty coverage. Limitation of Implied Warranties ANY IMPLIED WARRANTIES, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE LENGTH OF THIS WARRANTY. [. . . ]