User manual PEAVEY DUAL DELTAFEX

[. . . ] For information on other great Peavey products, go to your local Peavey dealer or visit us online at www. Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: To reduce the risk of electric shock, do not remove cover. WARNING: To prevent electrical shock or fire hazard, this apparatus should not be exposed to rain or moisture, and objects filled with liquids, such as vases, should not be placed on this apparatus. [. . . ] At this point, you have three options: 1. Press the Store button again to store into the current destination 2. Use the data wheel to choose a different location and then store 3. Press any other button to escape Store (Shortcut: pressing the EDIT button when in Preset mode will also enter Edit A mode. ) One of the four LEDs to the right of the display will light. Once in Edit mode, the EDIT button will scroll down through five parameters (if the effect is not off ): the four shown next to each LED, and all LEDs on, indicating output level for effect A or B. At each stop the display will show the value, and the data wheel can be used to edit it. The parameter being edited/displayed belongs to either effect block A or B, indicated by the Mode LEDs. The CONFIG button will step through the four configurations (see page 9), which control how the two effect engines are routed between the inputs and outputs for the current preset. Typically, you would set this before editing the parameters, since it can (and most likely will) affect the overall sound ­ mix ratios, depths, etc. Defeat Mode: This mode can be entered via a momentary footswitch plugged into the DEFEAT jack on the rear of the unit. It can also be entered by holding the MODE switch for a full second. Defeat mode can be exited by another press of the footswitch, or a normal press of the MODE switch. The display will read "by" when in Bypass mode, and "mu" when in Mute mode. To change which mode is used, press the CONFIG button to alternate between them while in the Defeat mode. This is a global setting that the unit will remember when powered down. The data wheel can still be used to select presets while defeated. You will see the preset number for a moment, after which the "by" or "mu" will return to the display. The preset will load inaudibly, so you will hear it almost immediately when exiting defeat mode. If you need to simply see the current preset number while defeated, press the EDIT button to see it for a couple seconds. Bypass Mode: In this mode, the left input will be routed to the left output, and the right input will be routed to the right output (the input and output level knobs will still be active ­ it's not a hard-wired bypass). Use this mode when the unit is in a serial-type loop, such as a guitar amp's effects loop, between a mixer and amplifier, etc. [. . . ] Presets 00 to 49 are designed for mixer aux sends and parallel effects loops (where the audio from the Dual DeltaFex® is adding to the already audible dry sound). These are typically used with the defeat mode set to Mute. Presets 50 to 99 are designed for series-type applications (guitar amp serial effects loops, between guitar and amp, between CD player and mixer, etc. ) Mix parameters are generally set for the dry sound to come through the unit with the effected sound added to it. [. . . ]