User manual PEAVEY DYNAMIC SYSTEM CONTROLLER 12

[. . . ] Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point they exit from the apparatus. Note for UK only: If the colors of the wires in the mains lead of this unit do not correspond with the terminals in your plug, proceed as follows: a) The wire that is colored green and yellow must be connected to the terminal that is marked by the letter E, the earth symbol, colored green or colored green and yellow. B) The wire that is colored blue must be connected to the terminal that is marked with the letter N or the color black. C) The wire that is colored brown must be connected to the terminal that is marked with the letter L or the color red. [. . . ] This is the perfect console for small venue performances or home recording environments. Please read this guide carefully to ensure your personal safety as well as the safety of your equipment. XLR Mic inputs on all four channels Two Stereo channels with 1/4" inputs Three-band EQ on mono channels Two-band EQ on stereo channels Clip LEDs that thoroughly monitor clipping 48V phantom power switch Effects send on every channel with stereo return Zero latency record monitoring capabilities Control room out with level control Contour control switch 80 Hz low cut switch An active tone control (shelving type: ±15 dB) that varies the level of the low frequency range. Caution: Excessive low frequency boost causes greater power consumption and increases the possibility of speaker damage. This adjusts the level of the channel signal added to the effects mix. The effects send signal is taken after the channel level controls (7) so that adjustments made to the level control will also affect the send level. When rotated completely counterclockwise, the signal is present only on the left channel; when rotated completely clockwise, only in the right channel. This light normally indicates that the channel signal level is nearing the overload point. When it light, s roughly 3 dB of headroom remains. This is the channel output level control. This control establishes the nominal operating level for the channel. Because of the wide range of gain adjustment, signal levels up to +14 dBu can be accommodated. The tip is the positive input and should be used for unbalanced inputs. It has 20 dB less gain than the XLR input and does not have phantom power available. The Mic and Line inputs should not be used simultaneously. This control establishes the nominal operating level for the channel. The input gain can be adjusted over a wide range to compensate for soft voices or very loud drums. To maximize the signal-to-noise ratio, the gain should be set to the proper level with the channel level control (7) set to 0. If the Clip LED comes on and remains lit, try reducing the gain. When the 1/4" line inputs are in use, the XLR mic input is muted to prevent unwanted noise. These outputs can be used with Tip, Ring Sleeve (TRS) balanced or Tip Sleeve (TS) unbalanced connectors. These outputs can be used with Tip, Ring Sleeve (TRS) balanced or Tip Sleeve (TS) unbalanced connectors. [. . . ] Who This Warranty Protects This Warranty protects only the original retail purchaser of the product. 2 years *(+ 3 years) 2 years *(+ 1 year) 3 years *(+ 2 years) 1 year *(+ 1 year) 2 years 1 year 90 days [*Denotes additional warranty period applicable if optional Warranty Registration Card is completed and returned to Peavey by original retail purchaser within 90 days of purchase. What Peavey Will Do We will repair or replace (at Peavey's discretion) products covered by warranty at no charge for labor or materials. If the product or component must be shipped to Peavey for warranty service, the consumer must pay initial shipping charges. [. . . ]