User manual PEAVEY DYNAMIC SYSTEM CONTROLLER 23

[. . . ] Before using this apparatus, read the operating guide for further warnings. WARNING: When using electrical products, basic cautions should always be followed, including the following: Do not use this apparatus near water. Do not block any of the ventilation openings. install in accordance with manufacturer's instructions. [. . . ] This allows users to choose their desired crossover points for the high side of the mids and the highs for channel 1. This switch multiplies the value indicated on the Crossover Selector control for the high side of the mids and the highs times 10. When engaged, the range will change from 80 Hz - 900 Hz to 800 Hz - 9 kHz. This controls the output level of channel 1 low frequency signal (signal below the selected low/mid crossover point) present at the channel 1 low output XLR. This controls the output level of the channel 1 mid frequency signal (signal above the selected low/mid crossover point and below the selected mid/high crossover point) present at the channel 1 mid output XLR. This controls the output level of the channel 1 high frequency signal (signal above the selected mid/high crossover point) present at the channel 1 high output XLR. This mutes the output of the associated level controls. This switch selects between stereo 3-way operation and mono 5-way operation. This switch combines the sub frequencies of both channel 1 and channel 2 into a single output, which allows you to use half as many amplifiers as you would with two channels of subs. This control is used to optimize the channel 2 gain between the mixer and the power amps for channel 2. This clipping may be heard as distortion. If for any reason you are unable to power up this unit, remove the fuse by pulling out the holder. check to see if the fuse is operational. If not, then replace with a fuse of the appropriate value and rating. If the fuse continues to fail contact your nearest Certified Peavey Service Center. This control is used to optimize the gain between the mixer and the power amps. This clipping may be heard as distortion. While there should be no problem if this indicator flashes occasionally, it should never flash constantly or stay illuminated. This allows users to choose their desired crossover points for lows and the low side of the low-mids. This switch multiplies the value indicated on the Crossover Selector control for the lows and the low side of the low-mids times 10. When engaged, the range will change from 80 Hz - 900 Hz to 800 Hz - 9kHz. This allows users to choose their desired crossover points for the high side of the low-mids and the low side of the mids. [. . . ] When engaged, the range will change from 80 Hz - 900 Hz to 800 Hz - 9 kHz. This controls the output level of the mid frequency signal (signal above the selected low-mid/mid crossover point and below the selected mid/high-mid crossover point) present at mid output XLR. This controls the output level of the high-mid frequency signal (signal above the selected high-mid/mid crossover point and below the selected high crossover point) present at high-mid output XLR. This controls the output level of high frequency signal (signal above the selected high-mid/high crossover point) present at high output XLR. [. . . ]