User manual PEAVEY DYNAMIC SYSTEM CONTROLLER HDH

[. . . ] Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point they exit from the apparatus. Note for UK only: If the colors of the wires in the mains lead of this unit do not correspond with the terminals in your plug, proceed as follows: a) The wire that is colored green and yellow must be connected to the terminal that is marked by the letter E, the earth symbol, colored green or colored green and yellow. B) The wire that is colored blue must be connected to the terminal that is marked with the letter N or the color black. C) The wire that is colored brown must be connected to the terminal that is marked with the letter L or the color red. [. . . ] Lors de l'utilsation sur pied ou pole de support, assurez dans le cas de déplacement de l'ensemble enceinte/ support de prévenir tout basculement intempestif de celui-ci. Ruggedly constructed, DYNAMIC SYSTEM CONTROLLER HDH gives the operator the flexibility to establish a two-way stereo system or run in a three-way mono configuration. The DYNAMIC SYSTEM CONTROLLER HDH has variablestate filter controls with 24 dB per octave filters and utilizes XLR inputs and outputs for balanced operation from 20 Hz to 20 kHz. This 2-position rocker switch applies mains power to the unit when in the ON position. This switch selects between stereo 2-way operation and mono 3-way operation. This control is used to optimize the channel 1 gain between the mixer and the power amps for channel 1. Controls output level of channel 1 low frequency signal (signal below the selected crossover point) present at channel 1 low output XLR. Controls output level of channel 1 high frequency signal (signal above the selected crossover point) present at channel 1 high output XLR. This switch multiplies the value indicated on the Crossover Selector Control times 10. When engaged, the range will change from 100 Hz to 1 kHz through 1 kHz to 10 kHz. This control is used to optimize the channel 2 gain between the mixer and the power amps for channel 2. This controls the output level of low frequency signals (those below the selected crossover point) present at the low output XLR. This allows the user to choose their desired crossover point for lows and mids. This switch multiplies the value indicated on the Crossover Selector Control times 10. When engaged, the range will change from 100 Hz to 1 kHz through 1 kHz to 10 kHz. This controls the output level of mid signals (those below the selected crossover point) present at mid output XLR. This controls the output level of the highs (signals above the selected crossover point) present at high output XLR. This allows users to choose their desired crossover point for mids and highs. This switch multiplies the value indicated on the Crossover Selector Control times 10. When engaged, the range will change from 100 Hz to 1 kHz through 1 kHz to 10 kHz. an AC mains cord having the appropriate AC plug and ratings for the intended operating voltage is included in the carton. Never break off the ground pin on any equipment. [. . . ] Who This Warranty Protects This Warranty protects only the original retail purchaser of the product. 2 years *(+ 3 years) 2 years *(+ 1 year) 3 years *(+ 2 years) 1 year *(+ 1 year) 2 years 1 year 90 days [*Denotes additional warranty period applicable if optional Warranty Registration Card is completed and returned to Peavey by original retail purchaser within 90 days of purchase. What Peavey Will Do We will repair or replace (at Peavey's discretion) products covered by warranty at no charge for labor or materials. If the product or component must be shipped to Peavey for warranty service, the consumer must pay initial shipping charges. [. . . ]