User manual PEAVEY DYNAMIC SYSTEM CONTROLLER KBX

[. . . ] Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point they exit from the apparatus. Note for UK only: If the colors of the wires in the mains lead of this unit do not correspond with the terminals in your plug, proceed as follows: a) The wire that is colored green and yellow must be connected to the terminal that is marked by the letter E, the earth symbol, colored green or colored green and yellow. B) The wire that is colored blue must be connected to the terminal that is marked with the letter N or the color black. C) The wire that is colored brown must be connected to the terminal that is marked with the letter L or the color red. [. . . ] Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably in susceptibility to noise-induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. Government's Occupational Safety and Health Administration (OSHA) has specified the following permissible noise level exposures: According to OSHA, any exposure in excess of the above permissible limits could result in some hearing loss. Ear plugs or protectors to the ear canals or over the ears must be worn when operating this amplification system in order to prevent a permanent hearing loss, if exposure is in excess of the limits as set forth above. To ensure against potentially dangerous exposure to high sound pressure levels, it is recommended that all persons exposed to equipment capable of producing high sound pressure levels such as this amplification system be protected by hearing protectors while this unit is in operation. Lors de l'utilsation sur pied ou pole de support, assurez dans le cas de déplacement de l'ensemble enceinte/ support de prévenir tout basculement intempestif de celui-ci. DYNAMIC SYSTEM CONTROLLER KBX filters are set at ISO center frequencies within 3% accuracy. Whether on stage, in the studio or simply tweaking your home hi-fi system, the DYNAMIC SYSTEM CONTROLLER KBX is the EQ for you. Dual channel (31 bands each channel) 1/3 octave filter sets (ISO centers) 20 Hz to 20 kHz effective equalization range Constant Q filters Selectable 6 dB or 12 dB cut or boost range Level LEDs (-10 to +17 dB) Variable state low and high cut filters XLR inputs and outputs for balanced operation Bypass switch with status LED 10 dB boost /10 dB cut Level Control Ground lift switch Always begin the equalization process with all sliders at their center-detent (flat response) positions. Adjust the level up until the unit begins to feed back, then lower each fader until the feedback frequency is found. Lower the faders in small amounts to avoid adversely affecting sound quality. When this switch is engaged, the signal is routed from INPUT (10 and 11) though the low-cut filter to the channel's output. This 2-position rocker switch applies mains power to the unit when in the ON position. an AC mains cord having the appropriate AC plug and ratings for the intended operating voltage is included in the carton. Never break off the ground pin on any equipment. If the outlet used does not have a ground pin, a suitable grounding adapter should be used and the third wire should be grounded properly. To prevent the risk of shock or fire hazard, always make sure that the equalizer and all associated equipment is properly grounded. incorporated into this IEC MAINS CONNECTOR is the MAINS FUSE HOLDER. If for any reason you are unable to power up this unit, remove the fuse by pulling out the holder. check to see if the fuse is operational. If not, then replace with a fuse of the appropriate value and rating. If the fuse continues to fail contact your nearest Certified Peavey Service Center. [. . . ] Who This Warranty Protects This Warranty protects only the original retail purchaser of the product. 2 years *(+ 3 years) 2 years *(+ 1 year) 3 years *(+ 2 years) 1 year *(+ 1 year) 2 years 1 year 90 days [*Denotes additional warranty period applicable if optional Warranty Registration Card is completed and returned to Peavey by original retail purchaser within 90 days of purchase. What Peavey Will Do We will repair or replace (at Peavey's discretion) products covered by warranty at no charge for labor or materials. If the product or component must be shipped to Peavey for warranty service, the consumer must pay initial shipping charges. [. . . ]