User manual PEAVEY ECOUSTIC

[. . . ] Before using this appliance, read the operating guide for further warnings. WARNING: When using electrical products, basic cautions should always be followed, including the following: Do not use this apparatus near water. Do not block any of the ventilation openings. install in accordance with manufacturer's instructions. [. . . ] These controls set the amount and mix of delay/reverb and when depressed, turns on and off the chorus for the Mic channel. See the Tweak Section of this manual for more information and hidden features. As the knob is turned clockwise, the surrounding LED ring will light, indicating the amount and/or mix of reverb and delay. When turned fully counter-clockwise, the reverb/delay effects are off. When the knob is pushed in, the Chorus LED will light, indicating the chorus effects are engaged. As the control is turned clockwise, the surrounding LED ring will light, indicating the amount and/or mix of reverb and delay. When turned fully counter-clockwise, the reverb/delay effects are off. Repeatedly depressing this control cycles through the available effects: Doubler, Phaser, Chorus and Rotary Speaker. The LED adjacent to each effect name will light indicating which effect is active. Rotating this same control will change various parameters for each effect. the surrounding LED ring will also illuminate indicating relative value of the parameter being adjusted. This patch does not affect the operation of the amplifier or the signal continuing to the power amp and speakers. Note: A single button, shielded footswitch used in the preamp out jack can be used to mute the amplifier. Selects either Instrument (Pre EQ) or both the Instrument and Microphone channel (Post EQ) signals and routes to the Line Out XLR jack (38). Note: For proper ventilation, allow a minimum of 12" of clearance on all sides of the unit. Pressing the Mode Switch (44) selects between the two modes. In this mode, all three switches control effects presets. Their corresponding LEDs indicate which preset is active. Once desired settings are achieved utilizing the effects controls on the front panel, double-click one of the Preset switches (46, 48 or 50) to store the settings. Preset 2 (48) toggles between two effects and their respective settings. This button may be used as an on/off switch if one of the settings has no effects active. To use the Modulation LED (49) as a status indicator, the OFF (or lower setting) should be made with the LED dark and the ON (higher setting) made with the LED illuminated. [. . . ] The REV/DLY LED (51) will illuminate or go dark depending on status in step 10. By taking just a minute to properly set up the Freq Out, you can optimize this great feature of your new Ecoustic amplifier. Once you are set up and ready to play, set the level on the instrument channel and ensure the other channels are turned down. Then, turn the Ecoustic's gain and volume up to the desired 1 level. [. . . ]