User manual PEAVEY ECOUSTIC 112

[. . . ] For more information on other great Peavey products, go to your local Peavey dealer or online at www. Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: To reduce the risk of electric shock, do not remove cover. WARNING: To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. [. . . ] The LED adjacent to each effect name will light indicating which effect is active. Rotating this same control will change various parameters for each effect. the surrounding LED ring will also illuminate indicating relative value of the parameter being adjusted. The effects and their corresponding parameters are listed on the next page. To return to the factory effects settings, press and hold both the EFX ADJUST and REV/DLY controls while turning the amp on. The built-in Freq Out anti-feedback system, armed with sophisticated algorithms, distinguishes between music and feedback, seeking and destroying the feedback, leaving your music alone. If this eliminates the feedback, try pressing the Select switch (High Q setting) again which narrows the effected range of frequencies. If the feedback doesn't return, leave the switch in this position. If it does return, press Select twice more to return to the Low Q setting. It will not change with a preset change. Use this input with low impedance microphones or high-level sources equipped with a male XLR connector. Use with high impedance microphones or high-level sources equipped with a 1/4" phone plug. Reverses the phase of an instrument signal in order to reduce feedback or to correct out-of-phase conditions. This is especially useful when using both the Instrument and the Microphone input on a single instrument. This 3-position, rocker-type switch should normally be operated in its center or zero position. If the unit is producing an audible hum and/or noise, position the Ground Polarity switch to either the positive or negative position (+ or -). Note: If the noise or hum problem continues, consult your Authorized Peavey dealer, the Peavey Factory or a qualified service technician. an AC mains cord having the appropriate AC plug and ratings for the intended operating voltage is included in the carton. The mains cord should be connected to the amplifier before connecting to a suitable AC outlet. The mains cord supplied with the unit is heavy-duty, 3-conductor type with a conventional 120 VAC plug with ground pin. Never break off the ground pin on any equipment. If the outlet used does not have a ground pin, a suitable grounding adapter should be used and the third wire should be properly grounded. [. . . ] Adjust Reverb/Delay to preference using the REV/DLY (9 & 22) control on the front panel. press Preset 3 (50) to change to the other REV/DLY position. The REV/DLY LED (51) will illuminate or go dark depending on status in step 10. By taking just a minute to properly set up the Freq Out, you can optimize this great feature of your new Ecoustic amplifier. [. . . ]