User manual PEAVEY ED-100

[. . . ] a normal reset button length is about l/4". If this "thermal" type breaker does trip, simply pushing the button back in will reset it, after waiting a brief period of time to allow it to cool down. rEMEMBER , ALWAYS TURN THE POWER OFF BEFORE RESETTING THE BREAKER. If the breaker trips instantly each time you attempt to reset it, the unit should be taken to a qualified service center for repair. [. . . ] DDTTM should be enabled at all times to protect speakers. A setting of less than full clockwise will yield lower system noise at the expense of headroom. calibration indicates sensitivity in volts/dBV necessary to attain full available output. OPERATION NOTE: The input sensitivity rating of a power amplifier is the voltage level required to drive the Standard l/4" phone jacks with a special switching function to allow two modes of operation: a. For normal STEREO operation, each jack is used as the input to the respective channel (see fig. For dual-channel MONO operation, the A input jack may be used by inserting the plug only to the first "click" or detent (see fig. In this mode, the signal source is applied equally to both channels. 20 Hz to 20 kHz @ rated power, 8 ohms: Less than 0. Due to OUT efforts for constant improvements, features and specifications listed herein are subject to change without notice. For further information on other Peavey products, ask your Authorized Peavey Dealer for the appropriate Peavey catalog/publication. PEAVEY ONE-YEAR LIMITED WARRANTY/REMEDY PEAVEY ELECTRONICS CORPORATION ("PEAVEY") warrants this product, EXCEPT for covers, footswitches, patchcords, tubes and meters, to be free from defects in material and workmanship for a period of one (1) year from date of purchase, PROVIDED, however, that this limited warranty is extended only to the original retail purchaser and is subject to the conditions, exclusions, and limitations heremafter set forth: PEAVEY BO-DAY LIMITED WARRANTY ON TUBES AND METERS If this product contains tubes or meters, Peavey warrants the tubes or meters contatned in the product to be free from defects in material and workmanship for a period of ninety (90) days from date of purchase; PROVIDED, however, that this limited warranty is extended only to the original retail purchaser and is also subject to the conditions, exclusions, and limitations hereinafter set forth. Completion and mailing of WARRANTY REGISTRATION CARDS - Should notification become necessary for any condition that may require correction, the REGISTRATION CARD will help ensure that you are contacted and properly notified. Notice of address changes - If you move from the address shown on the WARRANTY REGISTRATION CARD, you should notify Peavey of the change of address so as to facilitate your receipt of any bulletins or other forms of notification which may become necessary in connectlon with any condition that may require dissemination of information or correction. WARNING: When using electric products, basic cautions should always be followed, including the following. Read all safety and operating instructions before using this product. All safety and operating instructions should be retained for future reference. This product should not be used near water, i. This product should be located so that its position does not interfere with its proper ventilation. It should not be placed flat against a wall or placed in a built-in enclosure that will impede the flow of cooling air. This product should not be placed near a source of heat such as a stove, radiator, or another heat producing amplifier. Connect only to a power supply of the type marked on the unit adjacent to the power supply cord. Never break off the ground pin on the power supply cord. [. . . ] This unit should be checked by a qualified service technician if: a. Anything has fallen or been spilled into the unit. The unit has been dropped or the enclosure damaged. The user should not attempt to service this equipment. [. . . ]