User manual PEAVEY EQ 215

[. . . ] As they start to feed back, note the LED activity on the EQ 215 feedback bands. move the faders to decrease the "identified" bands. Now you have eliminated a high percentage of potential feedback problems, before the performance even begins!Note: It is not uncommon for feedback to be active over several frequency bands. [. . . ] The LED will remain illuminated for a few seconds even after the feedback is gone. This is to allow you to see where the feedback is if the feedback goes away before any correction is made. If there is no feedback occurring, the LED of the frequency band with the most energy in it will illuminate. Just because the LED is illuminated does not mean that there is feedback occurring. INPUT 1/4" (2) 1/4" tip-ring-sleeve (stereo) jack provides balanced input when used with stereo (TRS) 1/4" plugs and 2-conductor shielded cables. When used with a mono 1/4" phone plug, the input is unbalanced. oUTPUT XLR (3) A transformer balanced , male XLR output provides line-balancing to other pieces of audio equipment (power amps , etc. ) Balanced output is recommended for rejection of hum, noise and outside interference (pin 2 positive, pin 3 negative). oUTPUT 1/4" (4) 1/4" phone jack is provided for unbalanced output termination. LINE CORD (120V Products only) (5) We have incorporated a 2-wire line (mains) cable for power on the EQ 215. 77 Maximum Boost and Cut Filter: +/- 15 dB Maximum Boost and Cut Gain (WideBand Gain): +/- 15 dB Low Cut Filter: 12 dB Per Octave Frequency: Min: 5 Hz Max: 200 Hz High Cut Filter: 12 dB Per Octave Frequency: Min: 5 kHz Max: 35 kHz All specifications are typical unless otherwise noted. Your remedies for breach of these warranties are limited to those remedies provided herein and Peavey Electronics Corporation gives this limited warranty only with respect to equipment purchased in the United States of America. Keep the PROOF OF PURCHASE In the event warranty service is required during the warranty period, you will need this document. There will be no identification card issued by Peavey Electronics Corporation 2. iMPORTANCE OF WARRANTY REGISTRATION CARDS AND NOTIFICATION OF CHANGES OF ADDRESSES: a. Completion and mailing of WARRANTY REGISTRATION CARDS--Should notification become necessary for any condition that may require correction the REGISTRATION CARD will help ensure that you are contacted and properly notified. Notice of address changes - If you move from the address shown on the WARRANTY REGISTRATION CARD, you should notify Peavey of the change of address so as to facilitate your receipt of any bulletins or other forms of notification which may become necessary in connection with any condition that may require dissemination of information or correction. WARNING: When using electric products, basic cautions should always be followed. Read all safety and operating instructions before using this product. All safety and operating instructions should be retained for future reference. This product should not be used near water, i. This product should be located so that its position does not interfere with its proper ventilation. [. . . ] Anything has fallen or been spilled into the unit. The unit has been dropped or the enclosure damaged. The user should not attempt to service this equipment. All service work should]d be done by a qualified service technician. [. . . ]