User manual PEAVEY ESCORT 2000

[. . . ] This clever design incorporates the speakers into the package, allowing the unit to be easily carried or pulled along on its luggage-style wheels. We think you'll agree that the Escort 2000 raises portable sound to a new level!4 XLR mic inputs with 15 V phantom power · 150 Watts of output power (75 Watts per channel) with DDTTM · Much of the setup of the EscortTM 2000 is similar to the setup of other sound systems, and many aspects require plain common sense. Safety should always be your first concern. [. . . ] Although it does an excellent job of getting the audience's attention, feedback should be avoided. When trying to deal with acoustic feedback it is always best to start looking at the placement of the mics and speakers in the system before resorting to equalization (EQ) adjustment. Make sure that the speakers are positioned to direct the sound toward the audience and away from the microphones. Position mics as close to the sound source as reasonable. Moving the mic closer increases the volume of the sound through the system without having to turn up the gain. microphone Usage Guidelines When practical , a single microphone is preferred. Additional microphones pick up more sound from the speakers and each mic has to be turned down a little to prevent feedback. However, if you have difficulty balancing the level of different individuals with one mic, or if you still cannot get sufficient gain, using more mics can offer an advantage. Giving several singers their own microphones, for example, allows placement of the microphones much closer to each singer. This increases the volume of the sound at the mic and far outweighs any detrimental effect from using multiple mics. It also allows the volume of each mic to be adjusted separately for proper balance. Reverb Adding reverberation to music can enhance the sound of that music. Add reverb in moderation because too much reverb makes vocals hard to understand. in most cases , it is best not to add reverb to the spoken word. Stereo / Mono Operation The EscortTM 2000 powered mixer has two input channels (4 & 5) for stereo line sources. If the speakers are situated so that most of the audience can hear both speakers (Fig. 10 A), it can be advantageous to run the system in stereo. if the audience primarily hears just one speaker (Fig. 10 B), or if you are using one speaker for the audience and the other for the stage performers, then it is best to run the system in mono. On CHANNEL 4, use the LEFT input only for MONO operation, or both LEFT and RIGHT inputs for STEREO. The MODE switch on CHANNEL 5 is also very useful for playing tapes or CDs with "split tracks". Setting the switch to MONO allows the signal from a source connected to either the LEFT or RIGHT input to be directed to both speakers. [. . . ] All service work should be done by a qualified service technician. This product should be used only with a cart or stand that is recommended by Peavey Electronics. Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably in susceptibility to noise induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. [. . . ]