User manual PEAVEY FEEDBACK FERRET

[. . . ] A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding plug. The wide blade or third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] (Note: Feedback often occurs around a range of pitches or frequencies, not necessarily a single pitch. By engaging this button, the Ferret widens the effective range of each filter and subsequently uses fewer filters to accomplish the same result. Panic Panic filters are a special class of filters designed to quickly control sudden, extreme feedback. Normal Activated after setting up for each venue. Lock Stops the Ferret from setting any new filters but keeps the filters already defined and in place. filters There are two sets of filters on the Ferret. Filters 9­16 are static and always set before the dynamic filters. Once these static filters are defined, they lock and maintain their status until they are reset. The dynamic filters (1­8) are those filters that change as input changes (i. Power The LED lights when AC power is supplied and the power switch is on. The mains cord should be connected to the unit before connecting to a suitable AC outlet. Fuse Domestic: 1A Slow-Blow Export: 500 mA Time Delay Power Switch This switch applies AC mains power to the internal power supply. When the unit is functioning, the Power LED on the front panel will illuminate. Front Panel Disable Switch When the Disable switch is engaged, all buttons on the front of the unit are disabled. Use this switch after you've set up your system. This will prevent any accidental changes to your current settings. Power Up Recall This button determines, upon power up, whether the unit recalls the last settings used or preset 1. The Feedback Ferret can be used in a variety of locations within a sound system. Place a Ferret at the input insert of every microphone or you could process many microphones together by placing a single Ferret on the output of a vocal subgroup. One of the most common connections is to install the Ferret between the mixer's output and the power amp's input. This mixer output may be from the main output or the monitor output, depending on your needs. You can also place the Ferret on a single channel's insert to eliminate feedback from a single microphone or instrument. [. . . ] (Note: If all or most of the filters light up it's probably an indication that it is a bad room, a bad system setup or you are just too loud! this mode automatically engages the Panic button. Your system should be performance ready! at this point , it is advisable to engage the Front Panel Disable Switch to minimize accidental changes. [. . . ]