User manual PEAVEY FOUNDATION

[. . . ] Refer servicing to qualified service personnel. WARNING: To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. Before using this appliance, read the operating guide for further warnings. Este símbolo tiene el propósito, de alertar al usuario de la presencia de "(voltaje) peligroso" sin aislamiento dentro de la caja del producto y que puede tener una magnitud suficiente como para constituir riesgo de descarga eléctrica. Este símbolo tiene el propósito de alertar al usario de la presencia de instruccones importantes sobre la operación y mantenimiento en la información que viene con el producto. [. . . ] Channel 4 has only one stereo input since its Input Selector Switch is used to select the Mic 2 Input (10). All output levels from your external equipment should be set to maximum levels without causing distortion. This can sometimes be more evident by listening to the specific channel in the Cue through headphones. One important thing to remember is that your objective is to place all channels at very close input levels. This will make for a smoother, more accurate transition from one device to another during crossfade and channel select operations. NOTE: All stereo inputs are RCA connectors with the tip wired positive. 5 8. PHONO INPUT GROUND SCREW Grounds from external turntable(s) should be connected at this point for a proper input connection. MIC 1 INPUT The Mic 1 Input is located on the top of your PM One. (See diagram on back. ) The Mic 1 Input is a balanced, low impedance controlled by the Microphone Fader (11). The Voice-over Switch (12) can be placed in the TALK position while the Mic 1 Input is active to temporarily drop the music level by 12 dB. MIC 2 INPUT The Mic 2 Input is a balanced, low impedance TRS 1/4" input controlled by the Channel Fader (13) of Channel 4. Bouncing back and forth between these inputs with little change in the Channel Fader should be easy to accomplish. The inputs to Channel 4 are very different. Use the Channel Input Select Switch to select between LINE and MIC 2. Note: DonÕt forget that MIC 2 is live when it is selected. The Voice-over Switch will control MIC 2. MIC 2 is an optional microphone input selectable only on Channel 4 to give you a second microphone input if needed. Placing the Voice-over switch in the TALK position will drop the MIC 2 level as wellas any music on the other channels. Only MIC 1 and its channel remain at normal operating levels while TALK is selected. MASTER CONTROLS This section describes the master controls, which are those controls that affect the channel mix and/or outputs. The signal produced by this section of the PM One is the signal found at the outputs. MASTER MONO/STEREO SWITCH This switch determines if the output is mono or stereo. In the MONO position, the the left and right signals are combined and the L and R outputs are identical. [. . . ] Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. Unplug this apparatus during lightning storms or when unused for long periods of time. Refer all servicing to qualified service personnel. [. . . ]